Chicago Electric 42933 operating instructions SKU For technical questions, please call

Page 11

secure them by partially tightening the two screw clamps built into the Base assembly.

6.Set the Arm (118) assembly column into the Column Base. Move the Arm slightly to the left or right until the column index knob locks into the arm support column.

The arm support column has nine positive stops: 0, 15, 30, 45, and 60° (left and right).

7.Attach the Elevating Handle assem- bly to the Arm using the Allen wrench (provided).

8.Attach the Saw Blade (17) to the Gear Shaft (19) and secure with the Outside Flange (16) and Bolt (15). Lock the Gear Shaft with the Stopper Pin (22) located at the front part of the Gear Case Cover (26).

Using a wrench, tighten the Bolt (15) over the Outside Flange (16), coun- terclockwise.

9.Place the Safety Guard (10) over the Saw Blade and tighten in place.

10.Install the anti-kickback pawl on the Safety Guard (10) with the pawls fac- ing the rear of the machine.

11.Set the height by loosening its lock knob and moving it up or down. Re- tighten again when set to the proper height.

12.Verify that no play exists in the car- riage, and that the arm, yoke, and bevel locks and clamps are tight.

13.Slip the Dust Guide (4) over the exhaust stem located on the Safety Guard.

SKU 42933

For technical questions, please call 1-800-444-3353.

Page 11

Image 11
Contents Distributed exclusively by Harbor Freight Tools For technical questions or replacement parts, please callContents Save all warnings and instructions for future reference General Tool Safety WarningsSave This Manual 25’ 50’ 100’ 150’ Nameplate Extension Cord125 V~ 3-Prong Plug and Outlet Radial Arm Saw Safety WarningsGrounding Instructions With Three Prong PlugsNot a safe method Stick Length Essential Straight Push-stick Features FunctionsDiagram not to scale Handle NotchFor technical questions, please call Vibration Safety Unpacking SpecificationsInstallation SKU For technical questions, please call Operating Controls For technical questions, please call Cord to the Radial Arm Saw AdjustmentsCutting Kerf Marks Mitre Cross Cutting OperationCross Cutting Compound Cross Cutting Bevel Cross CuttingOut-Rip Cutting Maintenance Problem Cause Solution TroubleshootingPart Description ’ty Parts ListRecord Product’s Serial Number Here Assembly DiagramAssembly Diagram Limited 90 DAY Warranty