Chicago Electric 42933 operating instructions For technical questions, please call

and secure the arm angle for various miter positions. Positive index stops are 0, 15, 30, 45, and 60° (left and right). Non-index stops can also be set within the range of the arm assembly.

Yoke Pivot- The Yoke Index Knob, located at the top of the Yoke (under the Carriage Arm) indexes the Yoke horizontally to 0° (crosscuts) or 90° (for rip cuts). Loosen the Yoke Pivot Clamp Handle and pull out the Yoke Index Knob. Turn the motor assem- bly until it locks at the index position. Lock the Yoke Pivot Clamp Handle.

Blade Angle – The Bevel Index Knob (74) and the Bevel Lock Knob (71) are used to set the Blade angle (variable or indexed). Loosen the Bevel Index Knob (71). Turn the motor assembly clockwise or counter- clockwise to the index notch of 0, 45, or 90°, or to a variable position without using the index notch. Tighten the Bevel Lock Knob by turning clockwise.

Depth of Cut – The Elevating Handle

(100)at the rear of the arm is used to raise and lower the height of the Saw Blade. Turn the Elevating Handle clockwise to raise the Saw Blade or counterclockwise to lower it.

SKU 42933 For technical questions, please call 1-800-444-3353. Page 13