Specifications
Power | 120 V~, 60 Hz, | |
Requirements | 20.9 A (start); 6.9 A (load); 1330 W | |
Motor | ||
electric brake | ||
| ||
Saw Blade | ||
Arbor | 5/8” | |
Crosscut Distance | 11” (maximum) | |
Rip Cut Distance | 20” (maximum) | |
Depth of Cuts | 45°: 2”; 90°: | |
Bevel Index Stops | 0, 45, 90° | |
Mitre Index Stops | Left and right: 0, 15, 30, 45, and 60° | |
Table Size | ||
Accessories | Blade Replacement: Item # 43204 |
Note: Performance of this tool may vary depending on variations in local line voltage. Extension cord usage may also affect tool performance.
•The workbench should be of the ap- propriate length and width to allow the operator to stand aside of the saw blade, whatever position the saw blade is in.
•The work area should have ade- quate, overhead,
•Lock the radial arm carriage before moving the unit.
Unpacking
When unpacking, check to make sure that all the parts are included. Refer to the Parts List and Assembly Drawing at the end of this manual. If any parts are miss- ing or broken, please call Harbor Freight Tools at
Installation
During the assembly and installation procedure, you may have to refer to the Parts List and Assembly Drawings located at the end of this manual.
1.Secure the Radial Arm Saw to a solid bench top (or table) by bolting (or clamping) the saw frame down to the bench top.
•The workbench must not be able to slide or tip over. Affix to floor if nec- essary.
•Position the Radial Arm Saw (or saw and bench) to slope slightly to the rear so the radial arm carriage will not roll forward due to gravity.
2.Turn the Base (152) assembly upside down. Attach Table A (127) squarely to the Base assembly using the four
3.Attach the table stabilizer Stands to both sides of the Base using four Hex Nuts (82), Washers (149), and Round Head Bolts (148).
4.Place the Table and Base assem- bly on the workbench, right side up. Secure to the workbench with nuts, bolts, and washers (not supplied).
5.Position Table B (126) and Table C (125), and the rip fence (guide) and
REV 01c
SKU 42933 | For technical questions, please call | Page 10 |