Out-Rip Cutting

9.Slide the stock to be ripped into the cutting area and verify that it slides easily beneath the Safety Guard, Anti-kickback Arm, and (optional) Spreader Plate, and there is no wobble space. Remove stock from cutting area.

10.Press the green Switch (122), squeeze the handle Trigger (93) (mo- tor starts), and push up on the Lock On Button.

11.From the side of the machine, feed the stock into the Saw Blade (against its rotation) using a (long) push stick.

WARNING: Do not use your hand to push the stock through the Saw Blade. Do not reach around the Saw Blade while it is running. Seri- ous injury can occur to hands and arms.

12.When the cut is complete, and before removing the stock, squeeze the Trig- ger or pull down on the Lock On But- ton, press the red Switch, and wait until the saw blade stops completely.

desired angle (variable or indexed, i.e., 45°).

4.Tighten the Bevel Lock Knob (71) and push in the Bevel Index Knob (74).

5.Press the green Switch (122), squeeze the handle Trigger (motor starts), and push up on the Lock On Button.

6.From the side of the machine, feed the stock into the Saw Blade (against its rotation) using a (long) push stick.

WARNING: Do not use your hand to push the stock through the Saw Blade. Do not reach around the Saw Blade while it is running. Seri- ous injury can occur to hands and arms.

7.When the cut is complete, and before removing the stock, squeeze the Trig- ger or pull down on the Lock On But- ton, press the red Switch, and wait until the saw blade stops completely.

Out-ripping is done when the in-rip posi- tion will not permit a wide enough cut. This function moves the Saw Blade to the front of the machine. This operation is the same as in-rip cutting (previously described), with the exception that the Pivot Yoke is turned so that the Handle is on the right side of the machine (opposite of the in-rip position).

1.Adjust the Saw Blade for In-rip cutting as described on previous page.

2.Loosen the Bevel Lock Knob (71) and pull out the Bevel Index Knob (74).

3.Turn the motor assembly clockwise or counterclockwise, selecting the

SKU 42933

For technical questions, please call 1-800-444-3353.

Page 18