Carrier 06E specifications Unit 07E Volts, A022, B027, B033, D044

Page 3

DIMENSIONS (in.)

	UNIT 07E	VOLTS	A	B	C	D	E	F	G	H	I
	A022	208/230	66	493/4	23/4	34	271/2	1	21	59/16	95/16
		460, 575	66	433/4	23/4	34	26	1	21	59/16	95/16

	B027	208/230	78	493/4	23/4	34	271/2	1	21	59/16	95/16
		460, 575	78	433/4	23/4	34	26	1	21	59/16	95/16

	B033	208/230	78	493/4	23/4	34	271/2	1	21	59/16	95/16
		460, 575	78	433/4	23/4	34	26	1	21	59/16	95/16

	D044	208/230	691/2	493/4	23/4	34	271/2	1	21	41/8	85/8
		460, 575	691/2	493/4	23/4	34	271/2	1	21	41/8	85/8

NOTES:

1.For standard service practices, such as trouble-

shooting and refrigerant charging, allow a minimum 2′-6″clearance around the unit.

2.Recommended service space for condenser tube removal is one condenser length at either end.

3.For compressor removal, allow a minimum 3′ wide access aisle to and from the unit.

4.Local codes or jurisdiction may prevail for unit clearances.

3

Fig. 2 — 07E Water-Cooled Condensing Units

Image 3

Contents Contents Safety ConsiderationsInstallation Electrical Connections B033 Unit 07E VoltsA022 B02706E Hermetic Compressor Units Electrical Data Compressor Motor With Circuit Breaker AUX DTSLLS Refrigerant PRE-START-UP06E Physical Data Unit 06ESTART-UP 07E Physical DataUnit 07E Capacity Control System ServiceFactory Switch Settings Protection DevicesContr Removing, Inspecting and Replacing Components FigCapacity Control NO.Suction Cutoff Unloader Operation Compressor Components 06E Shown Torque Values Lubrication SystemCompressor Running Gear Removal Suction and Discharge Valve Plate AssemblyWear Limits 06E Compressor Compressor Running Gear ReplacementMotor Removal Motor ReplacementMotor Alignment Forced Circulation Page Copyright 2002 Carrier Corporation