Attaching Accessories | Craftsman 572.24700 guide

Attaching Accessories--

The round extension on

the motor housing is the power take-off for driving

the sander, buffing wheel, and flexible shaft..

These are mounted on special adapters which fit into the power take-off

BE SURE THE MOTOR IS

TURNED OFF. Line up

. ,,i pin in the motor shaft with the slot in the adapter and press forward as far as it

will go,. Turn the wheel slowly until the adapter set screw comes into view. Then tighten lightly, This screw does not drive the shaft, it merely minimizes vibration and wheel drifting.. It does not have to be too tight.

Recommended Accessories

#2471 =Accessory Kit.. #26877--Fine Tooth blades #26878--Coarse Tooth blades.

#2544--4" Assorted aluminum oxide Sanding Discs.

It'sa scroll saw--Handleseverything from small scroll work to full size furniture work. Cuts up to standard 2 x 4's,18 ga. copper, 1/4" aluminum and steel

CUTLONG

LENGTHS

BEVEL CUT

It's a Disc Sander--For shaping small pieces, sanding rough edges, trueing up uneven surfaces,. Three disc grits permit fine, medium, coarse sanding°

SAND BEVELS

CONTOUR

Fer mere p easure and versatility add kit 2471

Attaching Flexible Shaft--Besure MOTOR IS RUNNING

before the cable is engaged, DO NOT REMOVE OR

LOOSEN SCREW IN NYLON COUPLING Insert the black nylon coupling over the power take-off. Push the

coupling on as far as it will go, and hold in place by

turning the coupling counterclockwise, To prevent the cable from becoming disconnected while the machine is running, simply grasp the handpiece and twist the cable one-half turn counterciockwise_

Flexible Shaft Handpiece--The handpiece is equipped

with a chuck accommodating 3 cottet sizes: !/8". ....

Lightweight, ptastic hand-

piece handles easily as a pencil Accommodates 1/32", 1/18", 3/32 '° and

I/8 '° collets Capacity 0135 to 1/8", Features oilLess

bronze bearing, quick- action chuck and neoprene covered shaft

3/32"_ . . !/16",. This handpiece does not require oiling or adjustments..

FLEXIBLE SHAFT PROVIDES EXTRA VERSATILITY

Chuck--Consistsof chuck tever, chuck cap and colleL Do not attempt to operate chuck lever while shaft is running, Depress chuck lever and rotate chuck cap by

hand until lock pin snaps into place, and stops the chuck

cap from running,. Place chuck wrench over chuck cap and loosen as shown in the illustration. The chuck lever

must be kept depressed during this operation° Any ac- cessory or drill should be inserted into the collet as far

DRILLINGROUTINGDEBURRING

as possible to prevent wobble during operation., Now tighten chuck cap as shown keeping lever depressed.. Avoid excessive tightening of the chuck cap

		CHUCK LEVER
	TO	TIGHTEN
			CHUCK CAP
i	CHUCK WRENCH	TO LOOSEN	COLLET
i	CHUCK WRENCH	TO LOOSEN

GRtNDI NG

SHARPENI NG

CARVENG

Finger Grip-A finger grip attachment is included as part of this kit. It easily slips onto the front of the hand- piece and is used for precise control when doing close tolerance work.,

For best results, use the flexible shaft with a delicate touch. To prevent stalling the motor, press the tool lightly against the work, and never force the toot beyond its capacity°