LOCK LEVER,,
BLADE GUIDE
ASSEMBLY
SMALL
COMBINATION
SQUARE
TABLE
LOCKKNOB
SCALE
INDICATOR
BLADEGUIDE
To Adjust Thrust Bearings
•Adjust the thrust bearings first. Using the 118in. hex key, loosen the thrust bearing screw.
Note: The thrust bearing screw is the upper cap screw located on the right side of the blade guide assembly. It is the lower cap screw on the right side of the frame below the table for the lower bearing.
•Move the thrust bearing to within 1/64 in. of the blade. Tighten the thrust bearing screw securely. Repeat this procedure on the lower thrust bearing, located below the table.
Note: The thrust bearing is to support the back edge of the blade while cutting. The blade should not contact the bearings when you stop cutting. It is important that both thrust bearings be adjusted equally.
To Adjust Blade Guide Support
ANGLI |
|
KNOB | Fig. 17 |
|
ADJUSTING THRUST BEARINGS, BLADE
GUIDE SUPPORT, AND BLADE GUIDES See Figures 18, 19, and20.
The upper and lower blade guides and thrust bearings support the band saw blade during cutting operations. The adjustment of the guides and bearings should be checked whenever a different blade is installed.
_, WARNING; To prevent accidental starting that could cause possible serious personal injury,
turn off the saw and unplug the saw before making adjustments.
GUARDREMOVED
BLADE
•Next, adjust the position of the blade guide support. Loosen the bottom screw on the right side of the blade assembly using the hex key.
•Slide the blade guide support on the shaft until the front edge of the blade guides are about 1164 in. behind the gullet of the blade. Tighten the screw securely. Repeat this procedure for the lower blade guide support.
Note: The lower blade guide support screw is the top screw located on the right of the saw frame under the
table. See Figure 19.
_, WARNING: Never operate saw without blade guard secured in place. To do so could result in
possible serious personal injury.
BLADEGUIDE
SUPPORTSCREW
THRUSTBEARING
SCREW
| SCREW | BLADEGUIDE | THRUSTBEARING |
|
| ||
D |
| SCREWS |
|
BLADEGUIDE | BLADE GUIDE | LOWER BLADE GUIDE | |
SCREWS | SUPPORT SCREW | ||
|
|
| Fig. 19 |
| BLADE GUIDE ASSEMBLY |
|
|
| Fig. | 18 |
|
17