Small Combination Square, #2 Philupsscrewdrive

_i, WARNING: To prevent accidental starting that could cause possible serious personal injury,

assemble all parts to your saw before connecting it to power supply. Saw should never be connected to power supply when you are assembling parts, making adjustments, installing or removing blades, or when not in use.

•Carefully remove all parts from the carton and place the saw on a level work surface. Separate and check against the list of loose parts.

_k WARNING: If any parts are missing, do not operate this tool until the missing parts are

replaced. Failure to do so could result in possible serious personal injury.

•Do not discard the packing materials until you have carefully inspected the saw, identified all parts, and satisfactorily operated your new saw.

Note: If any parts are damaged or missing, do not attempt to plug in the power cord and turn the switch on until the damaged or missing parts are obtained and are installed correctly.

Check all loose parts from the box with the list below. For below have been drawn actual size. Assemble according

B.	Hex Nut (1/4-20)		3
C.	Wing Nut (1/4-20)		1
D.	Truss	Head Screw (1/4-20 x 5/8 in.)	1
E.	Screw	(M5 x 8)	1
F.	Scale	Indicator	1
G.	Throat	Plate	1
H.	Hex Key (1/8 in.)		1
I.	Saw Table (not shown)		1
J.	Owner's Manual (not shown)		1

The following tools (not included) are needed for assembly and alignment:

•#'2 Phillips Screwdriver

•Adjustable Wrench

•Small Combination Square

•5/16 in. Socket or Nut Driver

SMALL

COMBINATION

SQUARE

your convenience when identifying parts, items A-H to the instructions on the following pages.

Fig. 2

#2 PHILUPSSCREWDRIVE

5116in. SOCKET/NUTDRIVER

Fig. 3