EXTENSION CORDS
Use only
sion cord heavy enough to carry the current that the tool will draw. An undersized extension cord will
cause a drop in line voltage, resulting in a loss of power and causing the motor to overheat. Use the chart provided below to determine the minimum wire size required in an extension cord. Only round jack-
eted cords listed by Underwriter's Laboratories (UL) should be used.
Length of Extension Cord | Wire Size (A.W.G.) |
Up to 25 feet | 18 |
16 |
When working with the tool outdoors, use an exten- sion cord that is designed for outside use. This is indicated by the letters WA on the cord'sjacket.
Before using an extension cord, inspect it for loose or exposed wires and cut or worn insulation.
_, CAUTION: Keep the cord away from the cutting area and position the cord so that it will not be
caught on lumber, tools, or other objects during cutting.
ELECTRICAL CONNECTION
Your Sears Craftsman Band Saw is powered by a precision built electric motor. It should be connected to a power supply that is 120 volts, 60 Hz, AC only (normal household current). Do not operate this tool on direct current (DC). A substantial voltage drop will cause a loss of power and the motor will overheat. If the saw does not operate when plugged into an outlet, double check the power supply.
GROUNDING INSTRUCTIONS
In the event of a malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. This tool is equipped with an electric cord having an equipment- grounding conductor and a grounding plug. The plug must be plugged into a matching outlet that is properly installed and grounded in accordance with all local cedes and ordinances.
Do not modify the plug provided. If it will not fit the outlet, have the proper outlet installed by a qualified electrician. Improper connection of the equipment- grounding conductor can result in a risk of electric shook. The conductor with insulation having an outer surface that is green with or without yellow stripes is the
do not connect the
Check with a qualified electrician or service personnel if the grounding instructions are not completely understood, or if in doubt as to whether the tool is properly grounded.
Repair or replace a damaged or worn cord immedi- ately.
This tool is intended for use on a circuit that has an outlet like the one shown in Figure 1. It also has a grounding pin like the one shown.
GROUNDING
PIN
COVER01FGROUNDED
OUTLETBOX
Fig. 1
6