TO MAKE A BEVEL CROSS CUT
See Figure 44.
It is recommended that you place the piece to be saved on the left side of the blade and that you make a test cut on scrap wood.
_i, WARNING: Make sure the blade guard assembly is installed and working properly to avoid serious persona_ injury.
i Remove the rip fence by lifting the locking handle.
IMove the bevel locking lever to the right for Angle mode. Turn the blade adjustment handle until the bevel indicator is at the desired angle. Push the bevel locking lever securely to the left to lock the angle.
iSet the blade to the correct depth for the workpiece.
•Loosen the adjusting clamp on the miter fence. Set the miter fence to 90 degrees with either the quick- stop or the miter scale.
•Make sure the miter fence will not contact the blade as the wood feeds into the blade. Make a
trial pass of the miter table. The end of the miter fence should not contact the blade. Loosen the adjusting clamp to move it away from the blade if needed.
•Place a support (the same height as saw table) behind the saw for the cut work,
•Make sure the wood is clear of the blade before turning on the saw.
•Let the blade build up to full speed before moving the miter table to feed the workpiece into the blade,
•Hold the work with both hands and push the miter table to feed the work into the blade.
TO MAKE A BEVEL RiP CUT
See Figure 45.
It is recommended you make test cuts on scrap wood.
_1= WARNING: The rip fence must be on the left side of the blade to avoid trapping the wood and
causing kickback.
_lb WARNING: Make sure the blade guard assembly is installed and working properly to
avoid serious personal injury.
Before making this cut, use scrap wood to make an insert 5 in. wide, 22 in. long, and 3/4 in. thick. You may want to make others that are more than 5 in. wide.
| MITER FENCE |
QUICK | ADJUSTING CLAMP |
STOP |
|
Figure 44
WOODENINSERT RIP FENCE
MITER TABLE
BEVELLOCKINGLEVER Figure 45
•Remove miter fence, sliding miter table, and accessory table.
•Replace accessory table on the left side of blade.
Do not lock.
•Place the wooden insert between the accessory table and the saw table to support the workpiece. See Figure 45. Secure the wooden insert with screws as noted. Adjust the accessory table firmly against the wooden insert and lock securely. Note: The wooden insert should be attached with wood screws from the bottom, through the two holes provided in the casting. Securely trap the wooden insert between the accessory table and the saw table.
•Place sliding miter table on the right side of blade and lock securely.
•Attach the dp fence over the front and rear rails on the left side and lock securely. Reset the scaJe to the blade if needed.