Craftsman 137.218030, 137218030001 operating instructions Section, Motor, Saw

SECTION			PAGE	SECTION			PAGE
Warranty			2	Know Your Table		Saw	8
Product Specifications			2	Glossary	of Terms		9
Power	Tool Safety		3	Assembly	and Adjustments		10
Table	Saw	Safety	4	Operation	.............................................		17
Electrical Requirements and Safety			5	Maintenance			22
Accessories		and Attachments	6	Troubleshooting		Guide	23
Tools	Needed For Assembly		6	Parts List	.............................................		24
Carton	Contents		6	Push Stick Plan			28

ONE=YEAR FULL WARRANTY ON CRAFTSMAN TOOL

if this Craftsman tool fails due to a defect in material or workmanship within one year from the date of purchase, CALL 1-800-4-MY-HOME® TO ARRANGE FOR FREE REPAIR (or replacement if repair proves impossible).

if this tool is used for commercial or rental purposes, this warranty will apply for only ninety days from the date of purchase. This warranty applies only while this tool is in the United States.

This warranty gives you specific legal rights, and you may also have other rights, which vary, from state to state. Sears, Roebuck and Co., Hoffman Estates, IL 60179

IAkWARNING

Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains chemicals known to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:

•Lead from lead-based paints

•Crystalline silica from bricks, cement and other masonry products

•Arsenic and chromium from chemically treated lumber

Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals, work in a well ventilated area and work with approved safety equipment such as dust masks that are specially designed to filter out microscopic particles.

MOTOR
Type	Universal
Amps	15
Voltage	120
Hz	60
RPM (no load)	5000

[A WARNING]

SAW
Rip Capacity			With Extension	24 in. Right & Left
Blade	Size			10 in.
Blade	Arbor		Size	5/8 in.
Maximum		Cut Depth @ 90°		3 in.
Maximum		Cut Depth @ 45°		2-1/2 in.
Maximum		Diameter Dado		6 in. (Stackable only)
Maximum		Dado Cut Width		1/2 in.

To avoid electrical hazards, fire hazards or damage to the tool, use proper circuit protection.

This tool is wired at the factory for 110-120 Volt operation, it must be connected to a 110-120 Volt / 15 Ampere time delay fuse or circuit breaker. To avoid shock or fire, replace power cord immediately if it is worn, cut or damaged in any way.

Before using your tool, it is critical that you read and understand these safety rules. Failure to follow these rules could result in serious injury to you or damage to the tool.