ONE-YEAR FULL WARRANTY ON CRAFTSMAN TOOL
If this Craftsman tool fails due to a defect in material or workmanship within one year from the date of purchase, CALL
If this tool is used for commercial or rental purposes, this warranty will apply for only ninety days from the date of purchase. This warranty applies only while this tool is in the United States.
This warranty gives you specific legal rights, and you may also have other rights, which vary, from state to state. Sears, Roebuck & Co., Dept. 817 WA, Hoffman Estates, IL 60179
WARNmNG I
Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains chemicals known to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:
,Lead from lead=based paints
CrystaI!ine silica from bricks, cement and other masonry products
Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals, work in a well ventilated area and work with approved safety equipment such as dust masks that are specially designed to filter out microscopic particle&
MOTOR |
|
|
|
|
| |
Power | Source | 120V AC, 60Hz, 15 Amp | Beve! 45° L | 1=9/16 in. x 5=1/2 in. | ||
Arbor Shaft Size | 5/8 in. | 45 ° Miter and | 45° Bevel | 1=9/16 in. x 3=1/2 in. | ||
Speed | ...................................... | 4800 RPM (No load) | Rotating Table: |
| ||
Brake | ....................................... | Electric | Miter | Detent Stops | 0, 15, 22.5, 31.6, 45 ° R & L | |
Double | insulated | Yes | Bevel | Positive | Steps | 0, 45° |
MITER SAW |
|
|
|
|
| |
Cutting | Capacity: |
|
|
|
|
|
Crosscut | 2=5/8 in. x 5=1/2 in. |
|
|
|
| |
Miter 45 ° R & L | 2=5/8 in. x 3=1/2 in. |
|
|
|
| |
1_, WARNING I
To avoid electrical hazards, fire hazards or damage to the tool, use proper circuit protection°
This tool is wired at the factory for 110_120 Vott operation, it must be connected to a 110_120 Volt / 15 Ampere time delay fuse or circuit breaker. To avoid shock or fire, reptace power cord immediately if it is worn, cut or damaged in any way. Before using your too!, it is critical that you read and understand these safety rules.
Failure to follow these rules could result in serious injury to you or damage to the tool