IA WARNINGn
To avoidinjuryfrom accidentalstarting,alwaysturnswitchOFF and unplugthetoolbeforemoving,replacingtheblade
or making adjustments_
Consult your Sears Service Centre if for any reason the motor wi!! not run.
TROUBLESHOOTING | GUIDE o MOTOR | ||
PROBLEM |
| PROBLEM CAUSE | |
Brake does | not | 1. | Motor brushes not sealed or lightly |
stop blade | within 6 |
| sticking. |
seconds. |
| 2. | Motor brake overheated from use of |
|
|
| defective or wrong size blade or rapid |
|
|
| ON/OFF cycling. |
|
| 3. | Arbor bolt loose. |
|
| 4. | Other. |
Motor does not start 1. Fuse Blown | |||
|
| 2. | Brush worn. |
|
| 3. | Other. |
Brush spark when | 1. | Brush worn. | |
switch released. | 2. | Other. | |
SUGGESTED CORRECTIVE ACTION
1_ inspect / clean / replace brushes_ See MAINTENANCE section.
2.Use a recommended blade. Let cool down.
3.Retighten.
4.Sears Service Centre.
1.Check and
2.Replace brushes. See MAINTENANCE section.
3.Sears Service Centre.
1.Replace Brushes.
2. See Sears Service Centre.
TROUBLESHOOTING | GUIDE | o SAW | OPERATION |
|
|
|
|
|
|
|
|
| ||||
PROBLEM |
|
| PROBLEM | CAUSE |
| SUGGESTED | CORRECTIVE | ACTION | ||||||||
Blade hits table. | 1. | MisalignmenL |
| 1. | See ADJUSTMENT | section. |
|
| ||||||||
Angle of cut not | 1. | Miter table | unlocked. |
| 1. | See OPERATION | Section. |
|
| |||||||
accurate. |
| 2. | Sawdust | under table. |
| 2. | Vacuum | or blow out dust, |
|
| ||||||
Can'tadjust | miter. |
|
|
|
|
|
| WEAR |
| EYE PROTECTION. |
|
| ||||
Cutting | arm | wobbles. | 1. | Loose pivot points. |
| 1. | See ADJUSTMENT | Section. |
|
| ||||||
Cutting | arm | won't | 1. | Part failure. |
|
| 1. | Sears | Service | Centre. |
|
| ||||
fully raise, or blade | 2. | Pivot spring | not replaced properly | 2. | Sears | Service | Centre. |
|
| |||||||
guard won't fully |
| after service. |
| 3. | Clean | and lubricate | moving | parts. | ||||||||
close. |
|
| 3. | Sawdust | build=up. |
|
|
|
|
|
|
|
|
|
| |
Blade binds, jams, | 1. | Improper | operation. |
| 1. | See BASIC SAW OPERATION | section. | |||||||||
burns wood. |
| 2. | Dull blade. |
|
| 2. | Replace | or sharpen | blade. |
|
| |||||
|
|
| 3. | improper | blade size. |
| 3. | Replace | with | 10in. diameter | blade. | |||||
|
|
| 4. | Warped | blade. |
| 4. | Replace | blade. |
|
|
|
| |||
Saw vibrates | or | 1. | Saw blade | not round. |
| 1. | Replace | blade. |
|
|
|
| ||||
shakes. |
|
| 2. | Saw blade damaged. |
| 2. | Replace | blade. |
|
|
|
| ||||
|
|
| 3. | Saw blade | loose. |
| 3. | Tighten | arbor | bolt. |
|
|
|
| ||
|
|
| 4. | Other. |
|
|
| 4. | Sears | Service | Centre. |
|
| |||
24