Craftsman 113.2472T0 owner manual Unpacking and checking contents

b. LOWVOLTAGE- Althoughthemotoris de- signedfor operationon the voltage and fre-

quency specified on the motor nameplate, normal loads will be handled safely on voltages not more than 10% above or below the name- plate voltage. Heavy loads, however, require that voltage at motor terminals equals the voltage specified on nameplate.

5.Most motor troubles may be traced to loose or incorrect connections, overload, reduced input voltage (such as small size wire in the supply circuit) or to overly long supply circuit wire. Always check the connections, the load and the supply circuit whenever motor fails to perform

satisfactorily. Check wire size and length with the Wire Size Chart below.

WIRE SIZES

The use of any extension cord wil! cause some loss of power. To keep this to a minimum and to prevent

overheating and motor burn-out, use the table below

to determine the minimum wire size (A.W.G) exten- sion cord, Use only 3-wire extension cords which

have 3-prong grounding type plugs and 3-pole receptacles which accepts the tools plug.

CAUTION: For circuits that are farther away from electrical service box, the wire size must be increased

proportionately in order to deliver ample voltage to the saw motor.

Length of the		120 Volts Wire Sizes Required
	_
Conductor	1	(American Wire Gage Number)
0 - 25 Ft.	I	14
26 - 50 Ft.		12
51 - 100 Ft.	_	8

unpacking and checking contents

TOOLS NEEDED

MEDIUM		SCREWDRIVER
#2 PHILLIPS			SCREWDRIVER
::::::::::::::::			::::::: -,			3iB"	WRENCH
COMBINATION						T/16"	WRENCH
						9/16"	WRENCH
SQUARE
				7/16"	SOCKET
				3/8"	SOCKET	_	_
				9/16"
1/8"	HEX	"L"	WRENCH
5/32"	HEX	"L"	WRENCH	_		SOCKET WRENCH

WARNING: TO AVOID INJURY FROM UNEXPECT-

ED SfARTING OR ELECTRICAL SHOCK, DO NOT

PLUG THE SAW IN UNTIL ALL ASSEMBLY AND ALIGNMENT STEPS ARE COMPLETE. THE POWER CORD MUST REMAIN UNPLUGGED WHENEVER YOU ARE WORKING ON THE SAW.

Unpacking and Checking Contents

1.Separate all "loose parts" from packaging mater- ials and check each item with "Table of Loose

Parts" to make sure all items are accounted for, before discarding any packing material.

COMBINATION SQUARE MUST BE TRUE

STRAIGHT EDGE OF

BOARD 3/4-1NCH THICK

THIS EDGE MUST BE

PEFCTLY STRAIGHT

		I
		I
		1
		I
		I
		I
DRAW	LIGHT	I
LINE	ON BOARD
ALONG	THIS EDGE	__
		/L

SHOULD BE NO GAP OR OVERLAP HERE WHEN

SQUARE IS FLIPPED OVER IN DOTTED POSITION

WARNING: IF ANY PARTS ARE MISSING, DO

NOT ATTEMPT TO ASSEMBLE THE BAND

SAW, PLUG IN THE POWER CORD, OR TURN THE SWITCH ON UNTIL THE MISSING PARTS ARE OBTAINED AND ARE INSTALLED COR- RECTLY.

,Remove front table and front cover first while saw is being unpacked. To remove the front cover, pull the cover at the neck and underside of th roat area.