Norton Abrasives BBC207, BBC157, BBC547 owner manual II. Operation, Installing the Blade

Page 17

II.OPERATION

A.Installing the Blade

1.For Gasoline powered machines disconnect the spark plug and for Electrical Powered Machines disconnect from power source.

2.Remove the blade shaft nut, (Turn clockwise), and remove the outside collar.

3.Clean off any foreign particles on the clamping surfaces of both collars and on the mounting surface of the blade.

4.Place the blade on the blade shaft.

Use only Norton Clipper Diamond Blades.

5.Slide the outside blade shaft collar onto the blade shaft.

6.Tighten the blade shaft nut (clockwise) securely against the outside collar by using the Blade Shaft Wrench 19mm and Blade Shaft Flat Wrench 22mm as show in the figure below

Figure 11: Blade Tightening

7. Reconnect the spark plug or reconnect the electrical power.

Use Only Norton Clipper Diamond Blades

17

Image 17
Contents Form 7506 rev 2/2006 Compact Masonry SAW ModelsWarranty IV. Parts List Section III. MaintenancePreparation OperationHazard Symbols Safety PrecautionsDust and Silica Warning You Are Responsible For Your Safety Head Locking Handle AssemblyPart Number Head Locking Screw Removal Depth Limiting BoltPlastic Knob Attachment Leg AssemblyGuide-A-Cut Assembly Conveyor Cart AssemblyWrenches Water Curtain AssemblyWrench Placement Water Pump AssemblyDimensions/Weight BBC157/207/547 Series Masonry Saw SpecificationsCharacteristics Electric MotorGenerators Saws are wired for 115 Volt from the factoryElectrical Connections Electrical Connections Volt Wiring DiagramGasoline Engine II. Operation Installing the BladeHow To Use Step Cutting With Abrasive Blades II. Operation How To Use Blockbuster Compact For Wet Cutting How To Use Blockbuster Compact For Dry CuttingBelts III. MaintenanceBlade Shaft Bearings MotorEngine Lubrication of Sealmaster Bearings PumpOrdering Information Parts ListPower Unit Service Information Power Plant BBC547 Gasoline Item No Description Power Plant BBC157-207 Electric Frame Common All BBC157-207-547 Item No Description Part Number Cutting Head Common All BBC157-207-547 Locking Handle for cutting head was Cutting Table Common All BBC157-207-547 Conveyor Cart aka Cutting Table Complete Baldor Service Policy Honda Service Policy Sold and Serviced by