Norton Abrasives BBC207, BBC157, BBC547 owner manual Pump, Lubrication of Sealmaster Bearings

Page 23

Note: Never operate saw without bearing cover in place.

For normal conditions the grease should conform to the NLGI grade two consistency and be free of any chemical impurities such as free acid or free alkali, dust, rust, metal particles or abrasives.

For best results, the bearings should be lubricated while in operation.

Note:

Due caution for personal safety must be observed when servicing rotating equipment.

If necessary to lubricate while the bearing is idle, refer to lubrication table for the maximum grease capacity for the bearings.

LUBRICATION OF SEALMASTER BEARINGS

 

Shaft Sizes

Maximum Grease Capacity of Bearing

 

 

 

 

Chamber in Ounces

 

 

1/2" to 3/4"

.09

 

 

7/8" to 1-3/16"

1/4

 

 

1-1/4" to

1-1/2"

3/8

 

 

1-11/16" to

1-15/16"

3/4

 

 

2” to 2-3/16"

1-1/8

 

E. Pump

The submersible pump is mechanically driven by the V-belts and the sealed bearings require no lubrication. The pump is designed to run wet or dry, but for continued dry cutting, disconnect the pump.

1.Be sure to keep the pump clean - do not allow sediment to cake in the pump and clog it.

2.Keep all lines clean and running free.

3.Do not allow the Flex-cable to be pinched by the blade guard or anything else. Damage to the flex cable by pinching is not covered under any warranty

23

Image 23
Contents Form 7506 rev 2/2006 Compact Masonry SAW ModelsWarranty Operation III. MaintenanceIV. Parts List Section PreparationHazard Symbols Safety PrecautionsDust and Silica Warning You Are Responsible For Your Safety Head Locking Handle AssemblyPart Number Head Locking Screw Removal Depth Limiting BoltPlastic Knob Attachment Leg AssemblyGuide-A-Cut Assembly Conveyor Cart AssemblyWrenches Water Curtain AssemblyWrench Placement Water Pump AssemblyElectric Motor BBC157/207/547 Series Masonry Saw SpecificationsDimensions/Weight CharacteristicsGenerators Saws are wired for 115 Volt from the factoryElectrical Connections Electrical Connections Volt Wiring DiagramGasoline Engine II. Operation Installing the BladeHow To Use Step Cutting With Abrasive Blades II. Operation How To Use Blockbuster Compact For Wet Cutting How To Use Blockbuster Compact For Dry CuttingBelts III. MaintenanceBlade Shaft Bearings MotorEngine Lubrication of Sealmaster Bearings PumpOrdering Information Parts ListPower Unit Service Information Power Plant BBC547 Gasoline Item No Description Power Plant BBC157-207 Electric Frame Common All BBC157-207-547 Item No Description Part Number Cutting Head Common All BBC157-207-547 Locking Handle for cutting head was Cutting Table Common All BBC157-207-547 Conveyor Cart aka Cutting Table Complete Baldor Service Policy Honda Service Policy Sold and Serviced by