Norton Abrasives BBC157, BBC547, BBC207 owner manual You Are Responsible For Your Safety

Page 6

1.Before mounting any blade on the saw, the blade should be inspected for any damage which might have occurred during shipment, handling or previous use.

2.The blade collars and arbors should be cleaned and examined for damage before mounting the blade.

3.The blade must be properly fitted over the arbor with the drive pin on the outside collar projecting through the drive pinhole on the blade and inside collar.

4.The blade shaft nut, which is a left-hand thread nut, must be tightened securely against the outside blade shaft collar.

5.The blade must be operated within the specified maximum operating speed listed on the blade.

6.Turn water control valve to full to provide adequate coolant (4 to 6 gallons per minute) for diamond blades and wet cutting abrasive blades. Insufficient coolant could result in severe blade breakage or diamond segment separation.

7.The blade guard must be in place with the nose guard down and locked when the saw is running.

8.The operator should wear safety glasses and any other appropriate safety equipment.

9.When starting the saw, the operator should stand away and to the side of the blade.

10.If for any reason the saw should stall in the cut, raise the blade out of the cut. Check the outside blade shaft collar and nut for tightness. Inspect the blade for damage before restarting the saw. Use caution when resuming a cut. Be certain that the blade is in alignment with the previous cut.

11.During cutting operations, do not exert excess side pressure on the handles as a method of steering. Do not force the blade into the cut by lowering the blade too fast or by pushing the saw too fast.

You Are Responsible For Your Safety!!!

6

Image 6
Contents Compact Masonry SAW Models Form 7506 rev 2/2006Warranty Preparation III. MaintenanceIV. Parts List Section OperationSafety Precautions Hazard SymbolsDust and Silica Warning You Are Responsible For Your Safety Assembly Part NumberHead Locking Handle Depth Limiting Bolt Head Locking Screw RemovalLeg Assembly Plastic Knob AttachmentConveyor Cart Assembly Guide-A-Cut AssemblyWater Curtain Assembly WrenchesWater Pump Assembly Wrench PlacementCharacteristics BBC157/207/547 Series Masonry Saw SpecificationsDimensions/Weight Electric MotorSaws are wired for 115 Volt from the factory Electrical ConnectionsGenerators Wiring Diagram Electrical Connections VoltGasoline Engine Installing the Blade II. OperationHow To Use Step Cutting With Abrasive Blades II. Operation How To Use Blockbuster Compact For Dry Cutting How To Use Blockbuster Compact For Wet CuttingIII. Maintenance BeltsMotor EngineBlade Shaft Bearings Pump Lubrication of Sealmaster BearingsParts List Power Unit Service InformationOrdering Information Power Plant BBC547 Gasoline Item No Description Power Plant BBC157-207 Electric Frame Common All BBC157-207-547 Item No Description Part Number Cutting Head Common All BBC157-207-547 Locking Handle for cutting head was Cutting Table Common All BBC157-207-547 Conveyor Cart aka Cutting Table Complete Baldor Service Policy Honda Service Policy Sold and Serviced by