Norton Abrasives BBC207, BBC157, BBC547 owner manual How To Use Blockbuster Compact For Dry Cutting

Page 20

II. OPERATION

D. How To Use Blockbuster Compact For Dry Cutting

1.Use a proper blade, which is marked for dry cutting.

2.Remove the water curtain.

3.Disconnect the water pump.

4.Use "step" cutting as explained previously when using abrasive blades.

5.Use "jam" or "step" cutting when using dry cutting diamond blades.

E.How To Use Blockbuster Compact For Wet Cutting

Water may be supplied either by filling the water pan to within a half-inch of the top (for continuous use of the same water) or by placing a barrel of water next to the saw (for continuous flow of clean water). When using water from a barrel, remove water from pan and submerge it in water barrel. Remove the drain plug so the used water and sludge will drain from pan.

1.Prepare water supply.

2.Install water curtain on cutting head pivot bar.

3.Be sure the water pump is plugged into the receptacle on the back of the masonry saw motor. (The pump will start when the main switch is turned on.)

4.Handle on petcock should be turned in line with the water flow. Start motor and be certain that both sides of the blade are getting water.

5.Be sure that the water covers the bottom of the pump at all times. Do not let sludge and dirt get deep enough in the pan to block the pump inlet.

6.Use "step" cutting with abrasive blades as previously directed.

7.Use "jam" cutting or "step" cutting with diamond blades as previously described.

20

Image 20
Contents Compact Masonry SAW Models Form 7506 rev 2/2006Warranty III. Maintenance IV. Parts List SectionPreparation OperationSafety Precautions Hazard SymbolsDust and Silica Warning You Are Responsible For Your Safety Head Locking Handle AssemblyPart Number Depth Limiting Bolt Head Locking Screw RemovalLeg Assembly Plastic Knob AttachmentConveyor Cart Assembly Guide-A-Cut AssemblyWater Curtain Assembly WrenchesWater Pump Assembly Wrench PlacementBBC157/207/547 Series Masonry Saw Specifications Dimensions/WeightCharacteristics Electric MotorGenerators Saws are wired for 115 Volt from the factoryElectrical Connections Wiring Diagram Electrical Connections VoltGasoline Engine Installing the Blade II. OperationHow To Use Step Cutting With Abrasive Blades II. Operation How To Use Blockbuster Compact For Dry Cutting How To Use Blockbuster Compact For Wet CuttingIII. Maintenance BeltsBlade Shaft Bearings MotorEngine Pump Lubrication of Sealmaster BearingsOrdering Information Parts ListPower Unit Service Information Power Plant BBC547 Gasoline Item No Description Power Plant BBC157-207 Electric Frame Common All BBC157-207-547 Item No Description Part Number Cutting Head Common All BBC157-207-547 Locking Handle for cutting head was Cutting Table Common All BBC157-207-547 Conveyor Cart aka Cutting Table Complete Baldor Service Policy Honda Service Policy Sold and Serviced by