
Conveyor Cart Assembly:
Remove the Conveyor Cart and Back Stop from the Saws Water Pan, and the Wing Nuts, Carriage Bolts, Washers, and Cart Stop from the plastic bag. Slide one (1) Carriage Bolt thru each of the three (3) Square Holes located on the front of the Conveyor Cart. Slide the Back Stop Over each of the Carriage Bolts. Slide the Stop Assembly over the Carriage Bolt Located on the Left front of the Conveyor Cart NOTE: The Rubber Stop will faces away from the Conveyor Cart. Attach one (1) Washer and one (1) Wing Nut to each Carriage Bolt and Tighten. See Figure 6: Back Stop Assembly. Place the Conveyor Cart on the Machine see Figure 7: Conveyor Cart Installation.
Figure 6: Back Stop Assembly
Figure 7: Conveyor Cart Installation
Guide-A-Cut Assembly:
Attach the
10