Graco 332709B important safety instructions Emix, EQU0, EQU1

					Troubleshooting
Code	Type	Description	Problem	Cause	Solution
EF0#	Alarm	Timeout	Pump tried but was not	Pump dose valves did	Verify air pressure
		Startup	able to move to the	not actuate.	to solenoid valves.
		Pump #	home position within		Verify the valves are
			a specified amount of		actuating.
			time.	Motor could not drive	Verify motor is driving
				pumps and linear	the pump.
				actuator.
				Pump stroke length	Verify correct
				is shortened by	assembly of linear
				mechanical system	actuator and pump
				tolerance.	piston rods. See pump
					manual.
EF1#	Alarm	Timeout	Pump tried but was not	Pump dose valves did	Visually inspect valves
		Shutdown	able to move to the	not actuate.	to ensure they are
		Pump #	park position within a		operating properly;
			specified amount of		verify they have air
			time.		pressure above 85 psi
					(0.6 MPa, 6.0 bar).
				Pump is filled with	Observe motor and
				thick paint and could	drive assembly to
				not drive piston to	verify that the motor is
				end of stroke. Motor	generating force.
				or drive is worn or
				damaged.
EL00	Record	System	Record of power cycle	Indicates date and	n/a
		Power On	(ON).	time when system was
				started.
EM00	Record	System	Record of power cycle	Indicates date and	n/a
		Power Off	(OFF).	time when system was
				turned off.
EMIX	Advi-	Pump Off	The pumps are not	Pump power was	Start pumps by
	sory		powered and are	turned off or an error	pressing pump start
			unable to move.	occurred.	key on Advanced
					Display module.
EQU0	Advi-	USB Idle	USB download	Data transfer is	Remove USB device
	sory		process completed,	completed to the USB	from ADM.
			drive may be removed.	device.
EQU1	Record	USB Sys.	Settings were	User installed USB	n/a
		Settings	downloaded to USB	device in ADM USB
		Down-	drive.	port.
		loaded

332709B 15