Repair
Repairing the Advanced Display Module (ADM)
Replace the ADM
To replace the Advanced Display Module, disconnect the cable from the module and remove the module from the bracket. Install the new module on the bracket and attach the cable.
Figure 19 Replace the Advanced Display Module
3.Remove blue key token.
4.Insert and press black upgrade token (T) firmly into slot.
NOTE: There is no preferred orientation of the token.
Figure 21 Insert Token
5.Turn the power switch back on. The red indicator light (L) will flash until the new firmware is completely loaded.
6.Remove the token (T).
7.Replace the blue key token.
NOTE: The blue key token is required for proper operation.
8.Replace the token access panel.
Install Key Token or Upgrade Token
1.Shut off the PD2K power switch.
2.Remove the token access panel.
Figure 20 Remove Token Access Panel
36 | 332709B |