Graco 262906 important safety instructions Turn Spray-Prime/Drain valve to Spray

Page 13

6.Turn on water. Rinse paint off suction tube, prime tube and inlet screen. Close valve.

ti9413a

7.Connect shutoff valve and garden hose to suction tube. Leave prime tube in waste pail.

ti10443a

8. Turn Spray-Prime/Drain valve to SPRAY.

ti20407a

9. Open lever on shut-off valve.

ti10447a

10.Turn Pressure Control knob 1/4 turn clockwise.

1/4 turn

ti20418a

NOTE: Step 11 is for returning paint in hose back to paint pail. One 50-ft (15-m) hose holds approxi- mately 1-quart (1-liter) of paint.

Cleanup

11.Remove paint from hose.

a.Pull and hold gun trigger. Point gun into paint pail.

b.Turn power switch ON to begin pumping paint in hose back into paint pail.

ti5303a

ON

OFF

c.When water comes out of gun, continue to trig- ger gun, aiming gun into waste pail.

ti20411a

12.Continue triggering gun into waste pail for 1-2 minutes, until relatively clear water comes out of gun.

ti20412a

13. Turn Spray-Prime/Drain valve to PRIME.

ti20406a

332161A

13

Image 13
Contents Operation Grounding Instructions Fire and Explosion Hazard Equipment Misuse Hazard Component Identification Pressure Relief Procedure Extension Cords GroundingSetup Paint StartupSpray Test Pattern Clearing Clogs Perform Relieve Pressure Procedure, CleanupPower Flush Turn Spray-Prime/Drain valve to Spray OFF Technical Data Graco Information Graco Standard Warranty