Startup
1. Turn pressure control to lowest pressure.
ti20417a
2. Turn power ON.
ti5303a
ON
OFF
Startup
6.Inspect for leaks. Do not stop leaks with hand or a rag! If leaks occur, perform Pressure Relief Procedure, page 6. Tighten fittings.
7.Place siphon tube in paint pail.
PAINT
TIA
8.Trigger gun again into flushing pail until paint appears.
3.Increase pressure 1/4 turn to start motor. Allow fluid to circulate through drain tube for 15 seconds.
1/4 turn
ti20418a
4.Turn prime valve horizontal.Take spray gun trigger safety OFF.
Flush
ti2599c
9.Move gun to paint pail and trigger for 20 seconds. Set gun safety ON.
ti5313b
0!).4
ti20407a
5.Hold gun against grounded metal flushing pail. Trig- ger gun and flush 1 minute.
Flush
TIAB
Do NOT place hands in front of tip.
10.Screw tip assembly onto gun. Tighten. For gun assembly instructions, see gun manual.
ti20416a
332161A | 9 |