Engine
Removal
1.Remove Pinion Assembly/Rotor/Field/Pinion/ Clutch, Clamp and Clutch Housing, as in- structed on pages 16, 17, and 18.
2.Fig. 17. Disconnect all necessary wiring.
3.Fig. 18. Remove two locknuts (18) and screws (17) from base of engine.
4.Lift engine carefully and place on work bench.
NOTE: All service to the engine must be performed by an authorized HONDA dealer.
Installation
1.Lift engine carefully and place on cart.
2.Fig. 18. Install two screws (17) in base of engine and secure with locknuts (18). Torque to 200 in-lb (22.6 NSm).
3.Fig. 17. Connect all necessary wiring.
4.Install Pinion Assembly/Rotor/Field/Pinion/ Clutch, Clamp and Clutch Housing, as instructed on pages 16 and 17 and 18.
SPRAYER WIRING DIAGRAM
6 Wires
Red, Yellow, Green,
Blue, White, Black
Transducer
Air valve
Flow control
2X Red
2X Black
Flow sensor regulator
Fig. 17 | TI3110A |
|
70
71
Fig. 18
8710A