Troubleshooting
Relieve pressure; page 5.
PROBLEM | CAUSE | SOLUTION |
|
|
|
E=XX is displayed | Fault condition exists | Determine fault correction from table, page 14. |
|
|
|
Engine won’t start | Engine switch is OFF | Turn engine switch ON |
|
|
|
| Engine is out of gas | Refill gas tank. Honda Engines Owner’s Manual. |
|
|
|
| Engine oil level is low | Try to start engine. Replenish oil, if necessary. |
|
| Honda Engines Owner’s Manual. |
|
|
|
| Spark plug cable is disconnected or damaged | Connect spark plug cable or replace spark |
|
| plug |
|
|
|
| Cold engine | Use choke |
|
|
|
| Fuel shutoff lever is OFF | Move lever to ON position |
|
|
|
| Oil is seeping into combustion chamber | Remove spark plug. Pull starter 3 to 4 times. |
|
| Clean or replace spark plug. Start engine. |
|
| Keep sprayer upright to avoid oil seepage. |
|
|
|
False tripping of WatchDog | Operating conditions out of WatchDog param- | Turn pressure down. Contact Graco Technical |
system. EMPTY is displayed. | eters | Assistance to adjust WatchDog parameters. |
Pump does not run. | Low pump output; page 7. | Operate without WatchDog active; Manual |
| 309408. | |
|
| |
|
|
|
Engine operates, but dis- | Error code displayed? | Reference pressure control repair. Page 15. |
placement pump does not |
|
|
operate |
|
|
|
|
|
| Pump switch is OFF | Turn pump switch ON. |
|
|
|
| Pressure setting is too low | Turn pressure adjusting knob clockwise to |
|
| increase pressure. |
|
|
|
| Fluid filter (318) is dirty | Clean filter. Page 24. |
|
|
|
| Tip or tip filter is clogged | Clean tip or tip filter. Manual 309091. |
|
|
|
| Displacement pump piston rod is stuck due to | Repair pump. Manual 309277. |
| dried paint |
|
|
|
|
| Connecting rod is worn or damaged | Replace connecting rod. Page 8. |
|
|
|
| Drive housing is worn or damaged | Replace drive housing. Page 9. |
|
|
|
| Electrical power is not energizing clutch field | Check wiring connections. Page 13. |
|
| Reference pressure control repair. Page 15. |
|
| Reference wiring diagram. Page 25. |
|
| With pump switch ON and pressure turned to |
|
| MAXIMUM, use a test light to check for power |
|
| between clutch test points on control board. |
|
| Remove |
|
| and measure resistance across clutch coil. At |
|
| 70_ F, the resistance must be between 1.2 |
|
| ±0.2Ω (GMax 3900); 1.7 ±0.2Ω (GMax 5900); |
|
| if not, replace pinion housing. |
|
| Have pressure control checked by authorized |
|
| Graco dealer. |
|
|
|
| Clutch is worn, damaged, or incorrectly | Replace clutch. Page 10. |
| positioned |
|
|
|
|
| Pinion assembly is worn or damaged | Repair or replace pinion assembly. Page 10. |
|
|
|
6 309409