Graco Inc 309225W specifications Stowing Sprayer

Page 21

5. Turn pressure control knob

clockwise until the pump TIA turns on.

6.When storage fluid comes

out of prime tube (5-10 seconds) turn power switch OFF.

7. Turn Spray-Prime/Drain	TIA
7. Turn Spray-Prime/Drain
valve to SPRAY to keep
storage fluid in sprayer dur-
ing storage.	302!9

Storage

TIA

4.Secure a plastic bag around suction tube to catch any drips.

Stowing Sprayer

CAUTION

•Before storing sprayer make sure all water is drained out of sprayer and hoses.

•Do not allow water to freeze in sprayer or hose.

•Do not store sprayer under pressure.

1. Screw inlet screen onto suction tube.

WLD

5. Store sprayer indoors.

INLETLSCREEN

TIA

2. Coil hose. Leave it connected to sprayer.

WLD

3.Wrap power cord around cord wrap (XR7 and XR9 models).

309225W

21

Image 21

Contents Airless Sprayers Models SpecificationsFire and Explosion Hazard Equipment Misuse Hazard Installation Grounding and Electric RequirementsThermal Overload Component Identification Sprayers Pressure Relief Procedure OperationTrigger Lock Setup SetupOil- or Water-based Materials PrimingDX Model Pump Check ValvesUnclogging Spray Tip Installing Tip and BaseSelecting Tip Hole Size Tip SelectionChoosing the Correct Tip for the Job Reversible Tip Selection ChartSpraying Techniques Adjusting PressurePreventing Excessive Tip Wear Getting Started With Basic TechniquesShutdown and Cleaning Triggering GunPail Flushing Power Flush Closed Gun Fluid Filter Cleaning InstaClean Fluid Filter XR modelsLong Term Storage more Short Term Storage up toStowing Sprayer Troubleshooting Read Pump does not prime section Clean or replace InstaClean fluid Grounding and Electrical Tips Maintenance and ServiceCaring for Sprayer Pump PackingsHeight with folded Handle 26 in cm Technical DataFor Graco Canada Customers Graco Standard Warranty