Spray Tip Selection Chart
RAC SwitchTips, for use with G40 RAC Air Cap, Continued
NOTE: All tips in the Spray Tip Selection Charts below can be used with Model G40 guns equipped with RAC air cap 24C921.
FFT Fine Finish RAC Spray Tips
Order desired tip, Part No. FFTxxx, where xxx =
|
| ❖ Maximum Pattern Width at 12 in. (305 mm) | |||||
|
|
|
| in. (mm) |
|
| |
|
|
|
|
|
|
| |
| * Fluid Output at | 4 to 6 | 6 to 8 | 8 to 10 | 10 to 12 | 12 to 14 | |
| (150) | (200) | (250) | (300) | (350) | ||
Orifice Size in. | 2000 psi (14.0 MPa, 140 bar) | ||||||
|
|
|
|
| |||
(mm) | fl oz/min (lpm) |
|
| Spray Tip |
|
| |
|
|
|
|
|
|
| |
0.008 (0.203) | 8.8 (0.26) | 208 | 308 |
|
|
| |
0.010 (0.254) | 13.9 (0.41) | 210 | 310 | 410 | 510 |
| |
0.012 (0.305) | 19.9 (0.59) | 212 | 312 | 412 | 512 | 612 | |
|
|
|
|
|
|
| |
0.014 (0.356) | 27.0 (0.80) | 214 | 314 | 414 | 514 | 614 | |
WRX WideRAC Spray Tips
Order desired tip, Part No. WRxxxx, where xxxx =
| * Fluid Output at | ❖ Maximum Pattern Width at 12 in. (305 mm) | |
| 24 in. (610 mm) | ||
Orifice Size | 2000 psi (14.0 MPa, 140 bar) | ||
| |||
Spray Tip | |||
in. (mm) | fl oz/min (lpm) | ||
|
|
| |
0.021 (0.533) | 60.5 (1.79) | 1221 | |
|
|
| |
0.023 (0.584) | 72.7 (2.15) | 1223 | |
|
|
| |
0.025 (0.635) | 85.9 (2.54) | 1225 | |
|
|
| |
0.027 (0.686) | 100.0 (2.96) | 1227 | |
|
|
| |
0.029 (0.737) | 115.6 (3.42) | 1229 | |
|
|
| |
0.031 (0.787) | 131.8 (3.90) | 1231 | |
|
|
| |
0.033 (0.838) | 149.4 (4.42) | 1233 | |
|
|
| |
0.035 (0.889) | 168.3 (4.98) | 1235 | |
|
|
| |
0.037 (0.940) | 187.9 (5.56) | 1237 | |
|
|
| |
0.039 (0.991) | 208.9 (6.18) | 1239 | |
|
|
|
*Tips are tested in water.
Fluid output (Q) at other pressures (P) can be calculated by this formula: Q = (0.041) (QT) 
P where QT = fluid output (fl oz/min) from the above table for the selected orifice size.
❖Measured with NO airflow. Air assist will tend to reduce pattern lengths by 1 in. to 2 in.
34 | 3A0149C |