10.Allow the unit to draw paint until all air and impurities are cleansed from the system and the paint runs pure.
11.Turn the power Switch to its “OFF” position and secure the return tube in its normal operating position.
Purge and prime the Hose:
12.Do not attach the Spray Tip to the Gun when priming the Hose.
13.Unlock the Gun and turn the “PRIME/ SPRAY” knob to the “PRIME” posi- tion.
Oil Fill
Return
Hose
Pail | Priming | PRIME/ |
Bracket | Button | SPRAY Knob |
14.Aim the Gun at the side of the waste container and pull the Trigger. If us- ing
15.Hold the Trigger down and turn the power switch of the Sprayer to the “ON” position.
16.Turn the “PRIME/SPRAY” knob to the “SPRAY” position and hold the Trig- ger down until all air and impurities are cleansed from the Hose and the paint runs pure.
17.Release the Trigger. Turn the “PRIME/SPRAY” knob to the “PRIME” position. Squeeze the Trigger once to make sure that pressure is released.
Attach the Spray Tip:
18. Turn the Sprayer off.
Pull out and turn the key to lock the Trigger
Close the gauge at the end of the tip to lock the gun
19.Lock the Gun and thread the Spray
Tip on it.
Painting:
20.Fill a paint container (not included) with paint. Follow paint manufac- turer’s directions for the type of paint being used. Place the suction nozzle into the paint container.
21.Turn the power switch of the Sprayer to the “ON” position, turn the “PRIME/ SPRAY” knob to the “SPRAY” posi- tion, and turn the pressure switch to maximum.
22.When the motor cycles off, unlock the Gun and spray a test area.
SKU 99702 | For technical questions, please call | Page 12 |