Amana 1W10287572A warranty Check Your Vent System for Good Air Flow, Maintain Good Air flow by

Page 3

WARNING: For your safety, the information in this manual must be followed to minimize the risk of fire or explosion, or to prevent property damage, personal injury, or death.

Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

WHAT TO DO IF YOU SMELL GAS:

Do not try to light any appliance.

Do not touch any electrical switch; do not use any phone in your building.

Clear the room, building, or area of all occupants.

Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.

If you cannot reach your gas supplier, call the fire department.

Installation and service must be performed by a qualified installer, service agency, or the gas supplier.

WARNING: Gas leaks cannot always be detected by smell.

Gas suppliers recommend that you use a gas detector approved by UL or CSA.

For more information, contact your gas supplier.

If a gas leak is detected, follow the “What to do if you smell gas” instructions.

Check Your Vent System for Good Air Flow

Along with heat, dryers require good air flow to efficiently dry laundry. Proper venting will reduce your drying times and improve your energy savings. See Installation Instructions.

The venting system attached to the dryer plays a big role in good air flow.

WARNING

Fire Hazard

Use a heavy metal vent. Do not use a plastic vent. Do not use a metal foil vent.

Failure to follow these instructions can result in death or fire.

Service calls caused by improper venting are not covered by the warranty and will be paid by the customer, regardless of who installed the dryer.

Maintain Good Air flow by:

Cleaning your lint screen before each load.

Replace plastic or foil vent material with 4" (102 mm) diameter heavy, rigid vent material.

Use the shortest length of vent possible.

Use no more than four 90° elbows in a vent system; each bend and curve reduces air flow.

GoodBetter

Remove lint and debris from the exhaust hood.

Remove lint from the entire length of the vent system at least every 2 years. When cleaning is complete, be sure to follow the Installation Instructions supplied with your dryer for final product check.

Clear away items from the front the dryer.

3

Image 3
Contents Table of Contents Dryer SafetyPage Maintain Good Air flow by Check Your Vent System for Good Air FlowCycle Selector Timer Control Temperature ControlControl Panel Cycle Guide End of Cycle Signal ControlStopping and Restarting Dryer USEStarting Your Dryer Drying RackAs Needed Cleaning Cleaning the Dryer LocationCleaning the Lint Screen Every Load CleaningVacation and Moving Care Cleaning the Dryer InteriorRemoving Lint Changing the Drum LightNo heat TroubleshootingTimer does not noticeably advance Dryer will not runAccessories Disclaimer of Implied Warranties Limited WarrantyItems Excluded from Warranty This limited warranty does not coverVotre sécurité et celle des autres est très importante Sécurité DE LA SécheuseImportantes Instructions DE Sécurité Page Pour maintenir une bonne ventilation Contrôle du circuit dévacuation pour une bonne ventilationTimed Dry séchage minuté Tableau DE CommandeCommande de sélection de programme Minuterie Contrôle de la températureAIR DRY Signal de fin de programmeGuide DES Programmes Damp DRYArrêt et remise en marche Utilisation DE LA SécheuseMise en marche de la sécheuse Grille de séchageNettoyage avant chaque charge Nettoyage de lemplacement De la sécheuseEntretien DE LA Sécheuse Nettoyage du filtre à charpieNettoyage de lintérieur de la sécheuse Comment enlever la charpie accumuléeChangement de lampoule du tambour Bruits inhabituels DépannageLa sécheuse ne fonctionne pas Absence de chaleurAccessoires Garantie Limitée Éléments Exclus DE LA GarantieLa présente garantie limitée ne couvre pas U.S.A U.S.A. and CanadaW10287572A