Grizzly G0755 owner manual Depth Stop, Headstock Movement, Raising/Lowering Headstock

Depth Stop

The depth stop limits the downward movement of the cutting tool. With the use of the depth pointer adjustment knob (see D in Figure 12), it can be adjusted anywhere within 0"–5". This is useful when performing repeat operations.

Headstock

Movement

The headstock travels up and down the column, and tilts 90° left and right relative to the table.

Raising/Lowering Headstock

Loosen the lock handles shown in Figure 13, then use the Elevation (Z-Axis) Switch (see Figure 14) on the control panel to raise/lower the headstock.

Lock

Handles

Figure 13. Lock handles for headstock elevation.

Elevation

Switch

Figure 14. Elevation switch that controls

motorized head travel.

Model G0755 (Mfg. Since 1/13)

The Z-axis crank will rotate rapidly and may cause impact injuries if left attached during powered Z-axis operation. Always remove Z-axis crank before using the switch on the control panel.

The limit stops shown in Figure 15 stop head- stock travel when contacted by the limit block.

Limit

Stops

Limit

Block

Figure 15. Z-axis limit controls.

The headstock can also be raised/lowered by hand using the crank shown in Figure 16.

Crank

Figure 16. Z-axis crank.

Note: Lock the headstock in place by re-tighten- ing the lock handles before beginning operation to avoid unexpected headstock movement.

-21-