Grizzly G0755 owner manual Table Leadscrews, Quill Rack & Pinion

Table Leadscrews

Oil Type.......Model T23962 or ISo 68 Equivalent

Oil Amount	Thin Coat
Lubrication Frequency	40 Hrs. of Operation

Move the table as necessary to access the entire length of the X- and Y-axis leadscrews (see Figures 49–50), then use mineral spirits, shop rags, and a brush to clean them.

Quill Rack & Pinion

Oil Type	NLGI#2 Grease or Equivalent
Oil Amount		Thin Coat
Lubrication Frequency		90 Days of Operation

Move the quill up and down to gain full access to the rack and pinion (see Figure 51), then clean the teeth with mineral spirits, shop rags, and a brush.

X-Axis Leadscrew

Figure 49. X-axis leadscrew.

Note: Use a 4mm hex wrench to remove the way cover from the column and access the Y-axis leadscrew.

Y-Axis Leadscrew

Figure 50. Y-axis leadscrew.

Use a clean brush to apply a thin coat of oil to the leadscrew threads, then move the table through the X- and Y-axis paths to distribute the oil.

Replace the way cover before connecting the machine to power.

Pinion

Rack

Figure 51. Quill rack and pinion.

Use a brush to apply a thin coat of grease to the teeth, then raise/lower the quill several times to distribute the grease.

Note: Re-apply oil to the smooth outside surface of the quill that was removed during the cleaning process.

Model G0755 (Mfg. Since 1/13) -33-