Grizzly G0517g instruction manual

5.With the help of an assistant, place the mill/ drill headstock onto the column, as shown in Figure 10.

8.Thread the ball knobs onto one end of the downfeed handle shafts (the knobs go on the end of the shaft with the shorter threads).

9.Thread the downfeed handle shaft assem- blies into the pinion hub (Figure 13).

Figure 10. Headstock installed on base column.

6.Center the headstock over the table and tighten the lock handle shown in Figure 11.

Lock Handle

Figure 11. Securing headstock to column.

7.Thread the handwheel handles into the handwheels, as shown in Figure 12.

Figure 12. Installing handwheel handles. Model G0517 Mill/Drill

Pinion Hub

Figure 13. Downfeed handles installed.

Congratulations, your mill/drill is now assembled. For further information about installing the drill chuck or spindle sleeves, refer to the Operations section after performing the Test Run.

-13-