Operations, Head/Quill Travel, Table Travel

SECTION 4: OPERATIONS

NOTICE

If you have never used this type of machine or equipment before, WE STRONGLY REC- OMMEND that you read books, trade maga- zines, or get formal training before begin- ning any projects. Regardless of the con- tent in this section, Grizzly Industrial will not be held liable for accidents caused by lack of training.

Head/Quill Travel

The headstock can be raised/lowered with the elevation handle and column lock for Z-axis movement (Figure 15). The quill can be raised/ lowered with the downfeed handles and locked in place with the quill lock (Figure 16).

Column

Lock

Elevation Handle

Figure 15. Headstock elevation controls.

Downfeed

Handle

Quill Lock

Figure 16. Quill controls.

Table Travel

The mill/drill table can be moved in the X and Y axis.

Longitudinal Feed The longitudinal feed (X-axis) is moved by either handwheel (Figure 17) at the end of the table. One complete handwheel revolution moves the table 0.167". The longitudinal feed can be locked in position by locks located on the front of the table.

Handwheels

Longitudinal

Table Locks

Figure 17. Longitudinal feed controls.

Cross Feed The cross feed (Y-axis) is moved with the handwheel on the front of the table base (Figure 18). One complete revolution of the handwheel moves the cross feed table 0.167". The cross feed

	can be locked into position with the table locks.
	Cross Feed	Cross Feed
	Handwheel
		Table Locks

Figure 18. Cross feed controls.

Model G0517 Mill/Drill

-15-