ON
Ignition switch
STOP
Throttle trigger
Throttle trigger lockout
Starter handle
Push
Purge bulb
Fuel return line
STARTING COLD ENGINE
WARNING
WHEN ENGINE IS STARTED, CONFIRM IF THERE IS NOT ANY ABNORMAL VIBRATION OR SOUND. IF THERE IS ABNORMAL VIBRATION OR SOUND, ASK YOUR DEALER TO REPAIR.
•Stand the engine upright on a level surface.
•Place ignition switch in ON (START/RUN) position.
•Push purge bulb 3 to 4 times (or until fuel is visible in fuel return line).
•Shift choke lever to close position (START).
•Pull starter handle until the engine fires.
•Shift choke lever to full open position, and if necessary, start the engine again and allow to warm up before using.
-The clutch engages at approximately 3500 r/min. Therefore the drill bit may rotate at fast idle engine speed.
STARTING WARM ENGINE
•Place ignition switch in ON (START/RUN) position.
•Pull starter handle until the engine fires. - Do not use the choke.
START (Close)
RUN 
(Open)
Choke lever
STOPPING ENGINE
•Set throttle trigger in idle position.
•Place ignition switch in STOP position.
NOTE
When engine does not stop, shift choke lever to close position.
Check and repair ignition switch before starting the engine again.
10