Black & Decker DR260BR instruction manual Safety Warnings and Instructions Drills, Assembly, Motor

	Safety Warnings and Instructions: Drills
	WARNING: Shock hazard. When drilling or driving into walls, floors or wherever
	live electrical wires may be encountered, DO NOT TOUCH ANY METAL PARTS OF
•	THE TOOL! Hold the tool only by the plastic handle(s) / housing to prevent shock.
	Do not lock the tool ON when drilling by hand. Refer to Operating Instructions-Switching
•	On and Off.
	Hold drill firmly with both hands to	A
	control the twisting action of the drill
	(figure A). If your drill is equipped with a
	side handle, always use the side handle.
	WARNING: Drill may stall (if overloaded or
	improperly used) causing a twist. Always
	expect the stall. Grip the drill firmly to control
	the twisting action and prevent loss of control
	which could cause personal injury. If a stall
	does occur, release the trigger immediately
	and determine the reason for the stall before
•	re-starting.
	Always unplug the drill when attaching or
	removing accessories. When attaching
	accessories in the drill chuck, it is important to securely tighten the chuck using all three
	holes to prevent slippage. When using a keyless chuck, hand tighten firmly.
Motor
	Be sure your power supply agrees with nameplate marking. 120 Volts AC only means
	your drill will operate on standard 60 Hz household power. Do not operate AC tools on
	DC. A rating of 120 volts AC/DC means that your tool will operate on standard 60 Hz AC
	or DC power. This information is printed on the nameplate. Lower voltage will cause loss
	of power and can result in over-heating. All Black+Decker tools are factory-tested; if
	this tool does not operate, check the power supply.
Assembly
	WARNING: To reduce the risk of injury, before assembly,
	make sure that the tool is switched off and unplugged.
Attaching the side handle - DR560 (fig. B)			B
	If your drill is equipped with a side handle, it must be
•	installed properly to control the drill.
	Turn the grip counterclockwise until you can slide the side
•	handle (8) onto the front of the tool as shown.
	Rotate the side handle into the desired position.
•	Tighten the side handle by turning the grip clockwise.
Inserting a drill bit or other accessory (fig. C & D)
	WARNING: Do not attempt to tighten drill bits (or any
	other accessory) by gripping the front part of
	the chuck and turning the tool on. Damage to the		8
	chuck and personal injury may occur when changing
	accessories.
	WARNING: Always ensure the bit is	C
	secure before starting the tool. A loose bit
	may eject from tool causing possible
	personal injury.
Keyless two sleeve chuck (DR260) (fig. C)
•	Open the chuck (4) by grasping the rear half		10
	(9) with one hand and use your other hand to
	rotate the front sleeve (10) counterclockwise		4
	as viewed from the chuck end.
• Insert the accessory shaft into the chuck to about			9
•	3/4in. (19 mm) depth, centered in the jaws.
	Tighten securely by holding the rear half of
	the chuck and rotating the front sleeve in the
	clockwise direction as viewed from the chuck
	end.

6