Woodstock W1500 manual Shop Fox

Page 1

The Shop Fox®

ITEM W1500

P.O. Box 2309

Bellingham, WA 98227

COPYRIGHT © 1995 BY WOODSTOCK INTERNATIONAL, INC. REG.# VA 742-641

WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC.

REVISED APRIL 1998, PRINTED IN TAIWAN

Image 1

Contents Shop Fox Table of Contents Safety Instructions For All Tools Read Instructions Before Using The Shop FoxSection I Introduction Additional Safety Rules For The Shop Fox Commentary Piece Inventory Lock Knobs Section II AssemblyClamping Mechanism Mounting the clamping bracket to Shop Fox Angle BracketSliding Table Section III AdjustmentsHold-Down Bracket Face Plate Miter Bar Parallelism Planning Horizontal Clamping Section IV SET-UPClamping your Work Angled clamping for miter joint set-up Vertical Clamping Other Clamping MethodsClearance Section V Operations General ProceduresHorizontal Work Vertical Work Angled Work Using a bevel gauge for setting up Angled workSection VI Closure Model W1500 Shop FOX Section VII SpecificationsSection Viii Part Diagram Angle Bracket Section IX Part ListSection X Warranty