Woodstock W1500 Vertical Clamping Other Clamping Methods, Angled clamping for miter joint set-up

Page 12

D. Vertical Clamping

E. Other Clamping Methods

There are many ways to clamp your workpiece to the face plate of the Shop Fox®. However, when clamping your workpiece vertically to the face plate, always use two clamps.

1.There are 3/8" pre-drilled holes that accept our W1301 6" Vice Clamp (not included). These holes are strategically located on the face plate so you can position your workpiece and clamp it from any direction. Figure 8.

2.There are slots milled into the top edge of the face plate to accept bar type clamps (not includ- ed). Figure 9.

3.Standard C-clamps can be used anywhere on the face plate to secure your workpiece. Figure 10.

The 3/4" angle bracket included with the Shop Fox® is used to support and position a vertical workpiece at any angle between ±45° and 90°.

Figure 8. Vertical clamping for tenon cutting.

With a little bit of ingenuity you will find that there are numerous other ways in which to hold your workpiece to the Shop Fox®. C-clamps, bar clamps, toggle clamps, and other holding devices will give you the flexibility to create many innovative ways to hold your workpiece in position. Refer to the photos in this manual for some ideas on other clamping methods.

CAUTION: Do not clamp work with squeeze or speed type bar clamps.They do not have enough torque to hold the workpiece adequately.

Figure 9. Angled clamping for miter joint set-up.

Figure 10. Angled clamping for spline jointing on a

table saw.

Shop Fox®

-11-

Image 12
Contents Shop Fox Table of Contents Read Instructions Before Using The Shop Fox Safety Instructions For All ToolsSection I Introduction Additional Safety Rules For The Shop Fox Commentary Piece Inventory Section II Assembly Lock KnobsClamping Mechanism Angle Bracket Mounting the clamping bracket to Shop FoxSection III Adjustments Sliding TableHold-Down Bracket Face Plate Miter Bar Parallelism Section IV SET-UP Planning Horizontal ClampingClamping your Work Vertical Clamping Other Clamping Methods Angled clamping for miter joint set-upClearance General Procedures Section V OperationsHorizontal Work Using a bevel gauge for setting up Angled work Vertical Work Angled WorkSection VI Closure Section VII Specifications Model W1500 Shop FOXSection Viii Part Diagram Section IX Part List Angle BracketSection X Warranty