Woodstock W1500 manual Section II Assembly, Lock Knobs, Clamping Mechanism

Page 6

SECTION II: ASSEMBLY

A. Lock Knobs

To secure the Shop Fox® assembly to the base plate:

1.Thread each of two (2) lock knobs into the lock knob brackets mounted on the base plate. Figure 1.

2.Tighten sufficiently to hold the Shop Fox® to the base plate.

Figure 1. Lock knob installation.

B. Clamping Mechanism

To attach the horizontal clamping mechanism to the Shop Fox®:

1.Press the rubber clamping pad onto the head of the 2" carriage bolt.

2.Thread the carriage bolt into the toggle clamp. Figure 2.

3.Tighten the lock nut against the toggle clamp shoulder. Adjustment is made by loosening the lock nut and turning the carriage bolt in or out of the toggle clamp and then re-tightening the lock nut.

Lock Nut

Rubber Pad

Figure 2. Threading the clamping pad into the

toggle clamp.

Shop Fox®

-5-

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Shop Fox Table of Contents Read Instructions Before Using The Shop Fox Safety Instructions For All ToolsSection I Introduction Additional Safety Rules For The Shop Fox Commentary Piece Inventory Section II Assembly Lock KnobsClamping Mechanism Angle Bracket Mounting the clamping bracket to Shop FoxSection III Adjustments Sliding TableHold-Down Bracket Face Plate Miter Bar Parallelism Section IV SET-UP Planning Horizontal ClampingClamping your Work Vertical Clamping Other Clamping Methods Angled clamping for miter joint set-upClearance General Procedures Section V OperationsHorizontal Work Using a bevel gauge for setting up Angled work Vertical Work Angled WorkSection VI Closure Section VII Specifications Model W1500 Shop FOXSection Viii Part Diagram Section IX Part List Angle BracketSection X Warranty
Top Page Image Contents