Woodstock W1500 manual Angle Bracket, Mounting the clamping bracket to Shop Fox

Page 7

Clamping Mechanism Continued

4.Snap the toggle clamp bracket onto the inside vertical plate of the Shop Fox®. Figure 3.

5.See page 7 for ball-plunger adjustment.

Figure 3. Mounting the clamping bracket to the

Shop Fox®.

C. Angle Bracket

The Shop Fox® Face Plate features a variety of pre- drilled holes for mounting the angle bracket. The Angle Bracket is adjustable and supports your workpiece at a variety of angles. To mount the Angle Bracket:

1.Slide the aluminum bushing onto the thumb screw and insert the thumb screw through one of the end holes in the angle bracket. Figure 4.

2.Slide the thumb screw with angle bracket into the bottom hole located in the middle of the face plate. Slide on a washer and thread on the wing nut.

3.Repeat this process on the other end of the angle bracket so the thumb screw passes through the arc cut-out.

4.If making angled cuts between -45° and +45°, transfer the angle with a bevel gauge to the angle bracket and tighten the thumbscrews and wing nuts.

5.If making either -45°, 90° or +45° cuts, mount the angle bracket into any of the fixed position holes with both sets of thumbscrews, bushings, washers and wing nuts.

Figure 4. Mounting the Angle Bracket to the

Shop Fox®.

-6-

Shop Fox®

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Shop Fox Table of Contents Safety Instructions For All Tools Read Instructions Before Using The Shop FoxSection I Introduction Additional Safety Rules For The Shop Fox Commentary Piece Inventory Lock Knobs Section II AssemblyClamping Mechanism Mounting the clamping bracket to Shop Fox Angle BracketSliding Table Section III AdjustmentsHold-Down Bracket Face Plate Miter Bar Parallelism Planning Horizontal Clamping Section IV SET-UPClamping your Work Angled clamping for miter joint set-up Vertical Clamping Other Clamping MethodsClearance Section V Operations General ProceduresHorizontal Work Vertical Work Angled Work Using a bevel gauge for setting up Angled workSection VI Closure Model W1500 Shop FOX Section VII SpecificationsSection Viii Part Diagram Angle Bracket Section IX Part ListSection X Warranty
Top Page Image Contents