Moffat P8M, P12M Proofer / Holding Cabinet Cleaning, Stainless Steel Surfaces, Side Racks

Page 10

Cleaning

Cleaning Guidelines

Caution

Always turn ‘Off’ the electrical power supply at the mains supply before commencing cleaning.

This proofer / holding cabinet is not water proof. Do not use water jet spray to clean interior or exterior of the appliance.

To achieve the best results, cleaning must be regular and thorough. If any small faults occur, have them looked at promptly. Don't wait until they cause a complete breakdown.

NOTE:

Carefully read and follow the safety instructions on the label of the cleaning product to be used.

DO NOT use harsh abrasive scouring pads or abrasive detergents as they could damage the oven.

Ensure that any detergent or cleaning material has been completely removed after each cleaning.

To keep your proofer / holding cabinet clean and operating at peak efficiency, follow the procedures shown below:-

Proofer / Holding Cabinet Cleaning

NOTE:

If the proofer / holding cabinet usage is very high, the cleaning procedure should be carried out on a more frequent basis.

Stainless Steel Surfaces

a.Clean the exterior surfaces of the proofer / holding cabinet with, a damp cloth moistened with a mild detergent solution, or a soft bristled brush.

b.Hardened deposits or discolouration may require a good quality stainless steel cleaner. Always apply cleaner when the appliance is cold and rub in the direction of the grain.

c.Dry all components thoroughly with a dry cloth and polish with a soft dry cloth.

d.Ensure that the proofer / holding cabinet chamber is cool. Do not use wire brushes, steel wool or other abrasive materials to clean the interior of the cabinet.

e.Once a week, remove the side racks and water tank and clean any build up of product from the proofer / holding cabinet interior, using a mild anti bacterial detergent and hot water solution and a soft bristled brush.

f.Dry the proofer / holding cabinet thoroughly with a soft dry cloth.

Side Racks

a.To remove the side racks for cleaning, take hold of the centre rung of the rack and lift rack upwards.

b.Pull lower rack outwards to disengage the lower rack key-holes from the lower hanger studs.

Lower Hanger Studs

c.Lift the rack upwards to disengage the upper rack key-holes from the upper hanger studs and lift the rack out of the proofer / holding cabinet.

Lower Rack Keyhole

Lower Hanger Stud

Upper Rack Keyhole

and Hanger Stud

d.Clean the racks with a mild anti bacterial detergent and a hot water solution, using a soft bristled brush.

8

Image 10
Contents P8M / P12M Series Manufactured by Contents List Safety Information IntroductionPower Ratings SpecificationsTray Details Unpacking InstallationInstallation Requirements ClearancesWater Connection Max Inlet Pressure 80psi / 550kPaOperation Set Humidity Control 6 to the desired level Set the Function Control 2 to ‘ON’Set the Function Control 2 to ‘HOLD’ Stainless Steel Surfaces CleaningProofer / Holding Cabinet Cleaning Side RacksDoor Water TankWater Tank Element Condensation ChannelLamp Glass Fault Finding Fault Possible Causes RemedyElectrical Schematic Electrical Schematic P8M P12M Proofer Holding CabinetsReplacement Parts List Description