ADJUSTMENTS
REVERSIBLE
See Figure 2.
This tool has the feature of being reversible. The direction of rotation is controlled by a selector located above the switch trigger. With the drill held in normal operating position, the direction of rotation selector should be positioned to the left of the switch for drilling. The drilling direction is reversed when the selector is to the right of the switch. When the selector is in center position, the switch trigger is locked.
CAUTION:
To prevent gear damage, always allow chuck to come to a complete stop before changing the direction of rotation.
To stop, release switch trigger and allow the chuck to come to a complete stop.
KEYLESS CHUCK
See Figure 3.
A keyless chuck has been provided with your drill to allow for easy installation and removal of bits. As the name implies, you can hand tighten or release drill bits in the chuck jaws. Grasp and hold the collar of the chuck with one hand. Rotate the chuck body with your other hand. The arrows on the chuck indicate which direction to rotate the chuck body in order to GRIP (tighten) or RELEASE (unlock) the drill bit.
WARNING:
Do not hold the chuck body with one hand and use the power of the drill to tighten chuck jaws on drill bits. Chuck body could slip in your hand or your hand could slip and come in contact with rotating drill bit. This could cause an accident resulting in serious per- sonal injury.
REVERSE |
|
| DIRECTION OF |
0 | ROTATION |
1 | SELECTOR |
|
CENTER POSITION
(LOCK)
SWITCH
TRIGGER
FORWARD
Fig. 2
RELEASE (UNLOCK)
CHUCK BODY
20
CHUCK
GRIP COLLAR (TIGHTEN)
Fig. 3
Page 10