Important Information for RECHARG- ING HOT Batteries

OPERATION

IMPORTANT INFORMATION FOR RECHARG- ING HOT BATTERIES

When using your drill-driver continuously, the batteries be- come hot. You should let the batteries cool down for approxi- mately 30 minutes before attempting to recharge.

NOTE: This situation occurs when continuous use of your drill-driver causes the batteries to become hot. It does not occur under normal circumstances. Refer to “Charging Your Drill-Driver” earlier in this manual, for normal recharging of batteries. If the charger does not charge your batteries under normal circumstances, return both the drill-driver and charger to your nearest authorized service center for electrical check.

For more information on the battery recycling call

1-800-8 BATTERY.

TO INSTALL BATTERY PACK

■Place the direction of rotation selector in center posi- tion. See Figure 9.

■Place the battery pack in your drill. Align raised rib on battery pack with groove in drill's battery port. See Fig- ure 10.

■Make sure the latches on each side of your battery pack snap in place and that battery pack is secured in drill before beginning operation.

TO REMOVE BATTERY PACK

■Place the direction of rotation selector in center posi- tion. See Figure 9.

■Locate latches on side of battery pack and depress both sides to release battery pack from your drill. See Figure 4.

■Remove battery pack from your drill.

CAUTION:

When placing battery pack in your drill, be sure raised rib on battery pack aligns with groove in drill's battery port and latches snap in place properly. Improper assembly of battery pack can cause damage to inter- nal components.

SWITCH

See Figure 9.

To turn your drill ON, depress the switch trigger. To turn it OFF, release the switch trigger.

SWITCH LOCK

See Figure 9.

The switch trigger can be locked in the OFF position. This feature helps reduce the possibility of accidental starting when not in use. To lock the switch trigger, place the direction of rotation selector in the center position.

REVERSE

CENTER POSITION

(LOCK)

SWITCH

TRIGGER

FORWARD

BATTERY

PACK

DEPRESS

LATCHES TO

RELEASE

BATTERY PACK

DIRECTION OF

ROTATION

SELECTOR

Fig. 9

BATTERY

PORT

LATCHES

Fig. 10

Page 14