Ryobi SA960, SA120 manual Operation, Charging Your DRILL-DRIVER, To Charge

Page 13

 

OPERATION

WARNING:

BATTERY

 

PACK

Do not allow familiarity with the drill-driver to make you careless. Remember that a careless fraction of a

second is sufficient to inflict severe injury.CHARGING

ASSEMBLY

CHARGING YOUR DRILL-DRIVER

The battery pack for this tool has been shipped in a low charge condition to prevent possible problems. Therefore, you should charge it overnight prior to use.

Note: Batteries will not reach full charge the first time they are charged. Allow several cycles (drilling followed by re- charging) for them to fully charge.

TO CHARGE

See Figure 8.

Charge battery pack only with the charging assembly provided.

Make sure power supply is normal household volt- age, 120 volts, 60 Hz, AC only.

Connect charging assembly to power supply.

Place battery pack in charging assembly. Align raised rib on battery pack with groove in charging assembly.

See Figure 9.

Press down on battery pack to be sure contacts on battery pack engage properly with contacts in charging assembly. When properly connected, red light on charg- ing assembly will turn on.

Note: During the two year warranty period, if the charge indicator light (LED) fails to come on or goes out while charging battery pack, return charging assembly and battery pack to your nearest authorized service center for repair or replacing.

After normal usage, 3 hours or less of charging time is required to fully recharge battery pack. Note: If battery pack is completely discharged, 6 hours or longer of charging time is required to fully recharge battery pack.

The battery pack will become slightly warm to the touch while charging. This is normal and does not indicate a problem.

DO NOT place charging assembly in an area of ex- treme heat or cold. It will work best at normal room temperature.

When battery pack has been charged, disconnect charg- ing assembly from power supply and remove the bat- tery pack. This practice will increase battery life.

CHARGE

INDICATOR LIGHT (LED)

Fig. 8

Page 13

Image 13
Contents Model SA960 Model SA120 Save this Manual for Future ReferenceIntroduction Table of ContentsWork Area General Safety RulesService Specific Safety RulesImportant Safety Instructions for Charger Symbol Name DESIGNATION/EXPLANATION SymbolsUnpacking SpecificationsApplications InstructionsFeatures Model SA960 Reversible AdjustmentsRemoving Bits Installing BitsRight Wrong To Adjust Torque Adjustable Torque ClutchCharging Your DRILL-DRIVER OperationTo Charge To Remove Battery Pack To Install Battery PackImportant Information for RECHARG- ING HOT Batteries Drilling Variable SpeedMAG Tray Model SA120 Level DrillingGeneral MaintenanceChuck Removal To Retighten a Loose Chuck Battery Pack Removal and PREPARA- Tion for RecyclingBatteries Page Ryobi TECHNOLOGIES, INC Service Model NO. and Serial no