Ryobi SA120, SA960 manual Specific Safety Rules, Service

Page 4

GENERAL SAFETY RULES

SERVICE

Tool service must be performed only by qualified repair personnel. Service or maintenance performed by unqualified personnel may result in a risk of injury.

When servicing a tool, use only identical replace-

ment parts. Follow instructions in the Maintenance section of this manual. Use of unauthorized parts or failure to follow Maintenance Instructions may create a risk of shock or injury.

SPECIFIC SAFETY RULES

Hold tool by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring. Contact with a "live" wire will also make exposed metal parts of the tool "live" and shock the operator.

ADDITIONAL RULES FOR SAFE OPERATION

Know your power tool. Read operator's manual care- fully. Learn its applications and limitations, as well as

the specific potential hazards related to this tool.

Following this rule will reduce the risk of electric shock, fire, or serious injury.

Always wear safety glasses with side shields. Every- day glasses have only impact resistant lenses. They are NOT safety glasses. Following this rule will reduce the risk of eye injury.

IMPORTANT RULES FOR BATTERY TOOLS

Battery tools do not have to be plugged into an electrical outlet; therefore, they are always in operat- ing condition. Be aware of possible hazards when not

using your battery tool or when changing accesso- ries. Following this rule will reduce the risk of electric shock, fire, or serious personal injury.

Do not place battery tools or their batteries near fire or heat. This will reduce the risk of explosion and possibly injury.

WARNING: Batteries vent hydrogen gas and can ex- plode in the presence of a source of ignition, such as a pilot light. To reduce the risk of serious personal injury, never use any cordless product in the presence of open flame. An exploded battery can propel debris and chemi- cals. If exposed, flush with water immediately.

Do not charge battery tool in a damp or wet location.

Following this rule will reduce the risk of electric shock.

For best results, your battery tool should be charged in a location where the temperature is more than 50°F but less than 100°F. Do not store outside or in vehicles.

Under extreme usage or temperature conditions, bat- tery leakage may occur. If liquid comes in contact with your skin, wash immediately with soap and water, then neutralize with lemon juice or vinegar. If liquid gets into your eyes, flush them with clean water

for at least 10 minutes, then seek immediate medical attention. Following this rule will reduce the risk of serious personal injury.

Page 4

Image 4
Contents Save this Manual for Future Reference Model SA960 Model SA120Table of Contents IntroductionGeneral Safety Rules Work AreaSpecific Safety Rules ServiceImportant Safety Instructions for Charger Symbols Symbol Name DESIGNATION/EXPLANATIONSpecifications UnpackingApplications InstructionsFeatures Model SA960 Adjustments ReversibleRemoving Bits Installing BitsRight Wrong Adjustable Torque Clutch To Adjust TorqueCharging Your DRILL-DRIVER OperationTo Charge To Remove Battery Pack To Install Battery PackImportant Information for RECHARG- ING HOT Batteries Variable Speed DrillingLevel Drilling MAG Tray Model SA120General MaintenanceChuck Removal To Retighten a Loose Chuck Battery Pack Removal and PREPARA- Tion for RecyclingBatteries Page Service Model NO. and Serial no Ryobi TECHNOLOGIES, INC