Ryobi SAW BT3100 manual Table of Contents, Product Specifications

TABLE OF CONTENTS

■ Product Specifications	2
■ Rules for Safe Operation	3-6
■ Electrical	7
■ Glossary of Terms For Woodworking	8
■ Unpacking and Tools Needed	9
■ Loose Parts List	10-11
■ Features	12-14
Operating Components	13
Power Switch	13
Turn Your Saw On	13
To Turn Your Saw Off	13
To Lock Your Saw Switch	13
Blades	14
■ Assembly	15-20
Assembly Leg Stand	15
Assembly Storage Brackets	16
Mounting Leg Stand to the Table Saw Base	16
To Install Front and Back Rails	16-17
To Install Miter Table and Fence	17
To Install Accessory Table and Rip Fence	18
Removing/Replacing the Throat Plate	18
Blade and Guard Assembly	19
To Check Saw Blade Installation	20
To Install Blade Guard Assembly	20
■ Operation	21-32
Basic Operation	21
Causes of Kickback and Avoiding Kickback	21
Cutting Aids	21
Types of Cuts	22
Featherboard	23
How To Make a Featherboard	23
How To Mount a Featherboard	23
Settings And Adjustments	24-27
To Remove The Blade	24

To Check, Replace or Adjust The Riving Knife
and Blade Guard Assembly	25
To Adjust the Blade Depth	26
To Adjust the Blade Angle	26
To Set the Scale to the Blade	26
To Lock the Miter Table	27
Making Cuts	27-32
To Make a Straight Cross Cut	27
To Make a Miter Cut	28
To Make a Straight Rip Cut	28
To Make a Bevel Cross Cut	29
To Make a Bevel Rip Cut	29
To Make a Compound Miter Cut	30
To Make a Large Panel Cut	30
To Make Non-Through Cuts	31
To Make Dado Cuts	32
■ Maintenance	33-39
General Maintenance	33
Lubrication
Locker Bracket Assembly	33
Tilt / Elevating Mechanism	33
To Set Blade to 0 or 45 Degrees	34
To Check Alignment of the Rip Fence to
the Blade	34-35
To Adjust the Bevel Locking Lever	35
To Align the Miter Locking Clamps	35
To Adjust the Front and Rear Rail Clamps	36
To Adjust the Accessory Table	36
To Adjust the Sliding Miter Table Assembly	36
Checking Sliding Miter Table Assembly	37-38
Making Adjustments to Sliding Miter Fence Table
Assembly	38-39
■ Troubleshooting	40-41
■ Exploded View and Parts List	43-51
■ Parts Ordering / Service	52

PRODUCT SPECIFICATIONS

Blade Diameter		10 in. (254 mm)
Blade Arbor		5/8 in. (16 mm)
Cutting Depth at 0°		3-9/16 in. (90.5 mm)
Cutting Depth at 45°		2-1/2 in. (63.5 mm)
Rating	120 Volts, 60 Hz-AC Only, 15 Amperes
Output Speed		4,800 RPM
Net Weight Without Workstand		75 lbs. (34.1 kg.)
Net Weight With Workstand		107 lbs. (48.6 kg.)

Page 2