Ryobi TS1351 manual Cutting Warped Material, Clamping Wide Workpieces, See Figures 36

OPERATION

Bevel
Angle	Type of Cut
Setting

Left side, inside corner

°1. Top edge of molding against fence

33.852. Miter table set right 31.62°

3. Save left end of cut

	Right side, inside corner
33.85°	1.	Bottom edge of molding against fence
	2.	Miter table set left 31.62°
	3.	Save left end of cut

	Left side, outside corner
33.85°	1.	Bottom edge of molding against fence
	2.	Miter table set left 31.62°
	3.	Save right end of cut

45			4	5
31.6			31
	3		.6
			0
	0		3
	22.5		22.5
	15	0	15

Right side, outside corner

°1. Top edge of molding against fence

33.852. Miter table set right 31.62°

3. Save right end of cut

WRONG

WARNING:

Fig. 37

CUTTING WARPED MATERIAL

See Figures 36 and 37.

When cutting warped material, always make sure it is positioned on the miter table with the convex side against the fence as shown in figure 36.

If the warped material is positioned the wrong way as shown in figure 37, it will pinch the blade near the completion of the cut.

5				5
4			4
3			.6
1.6	30	3	31
	22.5	0
		22.5

15 0 15

To avoid a kickback and to avoid serious personal injury, never position the concave edge of bowed or warped material against the fence.

CLAMPING WIDE WORKPIECES

See Figure 38.

When cutting wide workpieces, such as 51 mm x 152 mm (52 in. x 6 in.), boards should be clamped with a C-clamp as shown in figure 38.

WIDE

BOARD

45 30 15

RIGHT

Fig. 36

45

31.631.6

3 3

30

	45
1	0
	3
	.5

15

Fig. 38

Page 26