Inlet located on the Back Panel of the Welder.
27.Adjust the flow rate of the gas by turning the Flow Adjust. The typical flow rate is
28.Installation of a
Operating Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
WARNING To prevent serious injury
from accidental operation:
Turn the switch to its off position before performing any inspection, maintenance, or cleaning procedures.
Work Piece and Work Area Set Up
1.Designate a work area that is clean and
2.Route the power cord along a safe route to reach the work area without creating a tripping hazard or exposing
the power cord to possible damage. The power cord must reach the work area with enough extra length to allow free movement while working.
3.Secure loose work pieces using a vise or clamps (not included) to prevent movement while working.
The work pieces should be firmly held together and in position while welding. The distance (if any) between the two work pieces must be controlled properly to allow the weld to hold both sides securely while allowing the weld to penetrate fully into the joint.
4.There must not be hazardous objects, such as utility lines or foreign objects, nearby that will present a hazard while working.
5.A barrier, such as a welding curtain or welding shroud should be put up to protect others in the work area and limit the spray of sparks.
General Operating Instructions
| Protective gear | |
Danger | ||
must be worn | ||
|
when using the MIG Welder;
SKU 97503 | For technical questions, please call | Page 12 |