Hitachi NB616X instruction manual If they

Page 13

Chapter 4 WIRING AND CONNECTION

(Note 3) : Please separate the main circuit wiring from the relay control circuit wiring.		If they
Power cables	R, S, T, U, V, W, P, PD,
	RB, N, R0, T0 etc.
Right angle

Input/Output signal lines

Control signal of STAT, ORT, LAC, PCLR, SAP, SAN, SBP, SBN,

EAP, EAN, EBP, EBN, POK, DSE, ZS, AP, AN, BP, BN, L, EP5,

EG5, CM1, CM2, P24, PLC etc.

Separate it 10cm or more.

have to be crossed, be sure that they must be crossed at right angle.

(Note 4) : Don’t make a short circuit between the EP5 and EG5 terminals. There is a danger of malfunctions.

(Note 5) : Isolate common signal for analog signal of the main body (L terminal of the logic card of SJ300) from common terminal of the SJ-FB.

(Note 6) : Please connect the encoder signal line properly so that the relationship among their phases become as shown below during rotation of the motor(Standard EG5).

EAP

EAN

EBP

EBN

EZP

EZN

Image 13

Contents SJ-FB Feed-Back Board Definitions and Symbols SafetyRevision History Table Page Page Contents Warranty of the unit Inquiry and Warranty of the UnitInspection upon packing Request upon inquiryOutline of SJ-FB How to Mount the option Board Outlook of SJ-FB Terminal assignment of the Option BoardSAP Function Explanation of the TerminalDSE Terminal connection diagramIf they Feed-back board initial setting Position of the setting switchMotor Setting 21 position of specification Switch setting flowchart Setting flowchart of the switch on the boardOperation Set Motor constant J bigger and bigger H024/H034 Function outline Orientation functionFunctions Data setting related to speed control Data settingWhen the motor is unstable Decrease position loop gain Data setting of the input-output terminal Control mode settingSpeed control ASR Position control APR Electronic gear functionData setting related to position control Wiring for Synchronized OperationPositioning completion Set ‘23’ to one Control block diagram of the electron gear function Forward/Reverse command + pulse train mode Pulse train mode selectionForward pulse train + Reversion pulse train mode Speed control mode is normally controlled by proportional Speed control P/PI switching functionResistor vs. Temperature Curves Cause and countermeasure of the option error Action selection in case of option errorProduct specification