Hitachi NB616X instruction manual Position of the setting switch, Feed-back board initial setting

Page 14

5.1 Position of the setting switch

Layout of SJ-FB

SWENC
	SWR
TM1	TM2

Chapter 5 SETTING

How to Set Switches SWENC and SWR [ON/OFF]

	O				1
	F				2
	F
	F

Slide to the (OFF) marked side of the switch to turn it off and the opposite side to turn it on.

Figure 5-1 Switch arrangement figure

5.2 Feed-back board initial setting

	Setting	Switch		Contents
	item	No.		Contents
	item	No.
			ON	Detection of disconnected A or B signal (EAP-EAN or EBP-
		1	ON	EBN) is valid.
				EBN) is valid.
	SWENC		OFF	Detection of disconnected A or B signal (EAP-EAN or EBP-
				Detection of disconnected A or B signal (EAP-EAN or EBP-
				EBN) is invalid.
		2	ON	Detection of disconnected Z signal (EZP-EZN) is valid.
		2	OFF	Detection of disconnected Z signal (EZP-EZN) is invalid.
			OFF	Detection of disconnected Z signal (EZP-EZN) is invalid.
			ON	Terminal resistance is provided between SAP and SAN (150
		1	ON	ohm).
		1		ohm).
	SWR		OFF	No terminal resistance is provided between SAP and SAN.
	SWR		ON	Terminal resistance is provided between SBP and SBN (150
				Terminal resistance is provided between SBP and SBN (150
		2		ohm).
		2		ohm).
			OFF	No terminal resistance is provided between SBP and SBN.

(Note) : All the switches are set to OFF as an initial setting.

14

Image 14

Contents SJ-FB Feed-Back Board Safety Definitions and SymbolsRevision History Table Page Page Contents Inspection upon packing Inquiry and Warranty of the UnitWarranty of the unit Request upon inquiryOutline of SJ-FB How to Mount the option Board Terminal assignment of the Option Board Outlook of SJ-FBFunction Explanation of the Terminal SAPTerminal connection diagram DSEIf they Position of the setting switch Feed-back board initial settingMotor Setting 21 position of specification Setting flowchart of the switch on the board Switch setting flowchartOperation Set Motor constant J bigger and bigger H024/H034 Orientation function Function outlineFunctions When the motor is unstable Decrease position loop gain Data settingData setting related to speed control Speed control ASR Control mode settingData setting of the input-output terminal Position control APR Electronic gear functionWiring for Synchronized Operation Data setting related to position controlPositioning completion Set ‘23’ to one Control block diagram of the electron gear function Forward pulse train + Reversion pulse train mode Pulse train mode selectionForward/Reverse command + pulse train mode Speed control P/PI switching function Speed control mode is normally controlled by proportionalResistor vs. Temperature Curves Action selection in case of option error Cause and countermeasure of the option errorProduct specification