.A complete Parts List is available at www.HobartWelders.com
4 | Tighten |
1
2
3
4
. Use pressure indicator scale to set | 5 |
a desired drive roll pressure. (Start |
with a setting of 2 or 3 on the scale.)
Pressure
Indicator
Scale
Be sure that wire is positioned in proper feed roll groove. Close and tighten pressure assembly, and let go of wire.
Remove gun nozzle and contact tip.
6 | 7 |
Turn power on. Be sure that Voltage range switch is set to range 1, 2, 3, or 4 to feed wire. Rotate knob until it “clicks” into detent. Wire will not feed if range switch is set between ranges.
8
Be sure that tip matches wire diameter. Reinstall contact tip and nozzle.
Press gun trigger until wire comes out of gun. (Keep gun cable as straight as possible.)
9
Tighten
1
2
3
4
WOOD
Feed wire to check drive roll pressure.
Tighten knob enough to prevent slipping.
Cut off wire. Close door.
Ref. 803